Sharp Carousel R-1501 Service-Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Service-Handbuch für Mikrowellenherd Sharp Carousel R-1501 herunter. Sharp Carousel R-1501 44 Seiten. Over the range models
Auch für Sharp Carousel R-1501: Handbuch zum Kochen (40 seiten), Handbuch zum Kochen (40 seiten)

Seite drucken

WARNING TO SERVICE PERSONNEL

Microwave ovens contain circuitry capable of pro-

ducing very high voltage and current, contact with

following parts may result in a severe, possibly

fatal, electrical shock.

(Example)

High Voltage Capacitor, High Voltage Power Trans-

former, Magnetron, High Voltage Rectifier Assem-

bly, High Voltage Harness etc..

Read the Service Manual carefully and follow all

instructions.

Before Servicing

1. Disconnect the power supply cord

remove outer case.

2. Open the door and block it open.

3. Discharge high voltage capacitor.

WARNING: RISK OF ELECTRIC SHOCK.

DISCHARGE THE HIGH-VOLTAGE

CAPACITOR BEFORE SERVICING.

The high-voltage capacitor remains charged about 60

seconds after the oven has been switched off. Wait for 60

seconds and then short-circuit the connection of the high-

voltage capacitor (that is the connecting lead of the high-

voltage rectifier) against the chassis with the use of an

insulated screwdriver.

Whenever troubleshooting is performed the power supply

must be disconnected. It may, in some cases, be necessary

to connect the power supply after the outer case has been

removed, in this event,

1. Disconnect the power supply cord, and then remove

outer case.

2. Open the door and block it open.

3. Discharge high voltage capacitor.

4. Disconnect the leads to the primary of the power

transformer.

5. Ensure that these leads remain isolated from other

components and oven chassis by using insulation tape.

6. After that procedure, reconnect the power supply cord.

When the testing is completed,

1. Disconnect the power supply cord, and then remove

outer case.

, and then

2. Open the door and block it open.

3. Discharge high voltage capacitor.

4. Reconnect the leads to the primary of the power

transformer.

5. Reinstall the outer case (cabinet).

6. Reconnect the power supply cord after the outer case is

installed.

7. Run the oven and check all functions.

After repairing

1. Reconnect all leads removed from components during

testing.

2. Reinstall the outer case (cabinet).

3. Reconnect the power supply cord after the outer case is

installed.

4. Run the oven and check all functions.

Microwave ovens should not be run empty. To test for the

presence of microwave energy within a cavity, place a cup

of cold water on the oven turntable, close the door and set

the power to HIGH and set the microwave timer for two (2)

minutes. When the two minutes has elapsed (timer at zero)

carefully check that the water is now hot. If the water

remains cold carry out Before Servicing procedure and re-

examine the connections to the component being tested.

When all service work is completed and the oven is fully

assembled, the microwave power output should be checked

and microwave leakage test should be carried out.

Don't Touch !

Danger High Voltage

R-1500

R-1501

R-1505

R-1506