Sharp Carousel R-1871 Betriebshandbuch - Seite 27

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Mikrowellenherd Sharp Carousel R-1871 herunter. Sharp Carousel R-1871 32 Seiten. Over-the-range microwave oven/hood system
Auch für Sharp Carousel R-1871: Broschüre & Specs (8 seiten), Installationshandbuch (9 seiten), Ergänzung zum Servicehandbuch (24 seiten), Installationsanleitung Handbuch (8 seiten)

Seite drucken

C L E A N I N G A N D C A R E

EXTERIOR

The outside surface is precoated metal and plastic.

Clean the outside with mild soap and water; rinse and

dry with a soft cloth. Do not use any type of household

or abrasive cleaner.

DOOR

Wipe the window on both sides with a damp cloth to

remove any spills or spatters. Metal parts will be easier

to maintain if wiped frequently with a damp cloth. Avoid

the use of harsh abrasives.

TOUCH CONTROL PANEL

Care should be taken in cleaning the touch control panel.

If the control panel becomes soiled, open the oven door

to inactivate the control panel before cleaning. Wipe

the panel with a cloth dampened slightly with water only.

Dry with a soft cloth. Do not scrub or use any sort of

chemical cleaners. Avoid the use of excess water. Close

door and touch STOP/CLEAR.

INTERIOR- AFTER MICROWAVE

COOKING

The oven walls, ceiling and floor are stainless steel.

Cleaning after microwave cooking is easy because no

heat is generated to the interior surfaces; therefore,

there is no baking and setting of spills or spattering. To

clean the interior surfaces, wipe with a soft cloth and

warm water. DO NOT USE ABRASIVE OR HARSH

CLEANERS OR SCOURING PADS. For heavier soil,

use mild soap; rinse thoroughly with hot water.

INTERIOR- AFTER CONVECTION,

MIX OR BROIL COOKING

Spatters may occur because of moisture and grease.

Wash immediately after use with hot, soapy water. Rinse

and polish dry. Harder to remove spatters may occur if

oven is not thoroughly cleaned or if there is long time/

high temperature cooking. If so, you may wish to

purchase an oven cleaner pad with liquid cleaner within

it-not a soap filled steel pad-for use on stainless or

porcelain surfaces. Follow manufacturer's directions

carefully and be especially cautious not to get any of

the liquid cleaner in the perforations on the wall or

ceiling or any door surfaces. Rinse thoroughly and

polish dry.

WAVEGUIDE COVER

The waveguide cover is located on the ceiling in the

oven cavity. It is made from mica so requires special

care. Keep the waveguide cover clean to assure good

oven performance. Carefully wipe with a damp cloth

any food spatters from the surface of the cover imme-

diately after they occur. Built-up splashes may over-

heat and cause smoke or possibly catch fire. DO NOT

REMOVE THE WAVEGUIDE COVER.

ODOR REMOVAL

Occasionally, a cooking odor may remain in the oven.

To remove, combine 1 cup water, grated peel and juice

of 1 lemon and several whole cloves in a 2-cup glass

measuring cup. Boil for several minutes using 100%

power. Allow to set in oven until cool. Wipe interior with

a soft cloth.

TURNTABLE/TURNTABLE

SUPPORT

The ceramic turntable and turntable support can be

removed for easy cleaning. Wash them in mild, sudsy

water; for stubborn stains use a mild cleanser and

scouring sponge as described above. They are also

dishwasher-safe using top rack.

OVEN RACKS

The high and low baking racks can be removed for easy

cleaning and stored away from the microwave oven

when racks are not needed. After each use, wash them

in mild, sudsy water. For any stubborn stains, use a

mild kitchen cleanser and scouring sponge as described

above. They are dishwasher-proof.

GREASE FILTERS

Filters should be cleaned at least once a month. Never

operate the fan or oven without the filters in place.

1. Pull the tab toward the front of the oven, down slightly

and remove the filter. Repeat for the other filter.

2. Soak the filters in a sink or dish pan filled with hot

water and detergent. DO NOT use ammonia or

other alkali; they will react with the filter material and

darken it.

3. Agitate and scrub with a brush to remove embed-

ded dirt.

4. Rinse thoroughly and shake dry.

5. Replace by fitting the filter back into the opening.

Grease

filter

Tab