Sharp 15JF-25S Service-Handbuch - Seite 10
Blättern Sie online oder laden Sie pdf Service-Handbuch für TV Sharp 15JF-25S herunter. Sharp 15JF-25S 37 Seiten.
Seite drucken•Colour Adjustment Procedure
The following adjustments should only be carried out when the CRT or IC801 are replaced.
Notes:
•
This adjustment must be done after warming up the unit for 30 minutes or longer with a beam current over 700
µA.
•
The red value «DRI-RS» should be fixed to 42. (Refer to "How to access Service Mode" section).
•
«DRI-GS» adjustment alters "Y" co-ordinate.
•
«DRI-BS» adjustment alters "X" and "Y" co-ordinates.
Adjustment Method 1 (using the signal generator, varying the picture signal)
1. Adjust G2.
2. Input a white pattern with burst signal from SCART.
3. Position the colorimeter in the centre of screen.
4. Adjusting input signal level, select a luminance of 70 nits.
5. Operate again in "Service Mode" and select «DRI-GS» and/or «DRI-BS» locations to obtain colour co-ordinates:
6. Re-set the TV with the mains switch button to store the adjustment and exit Service Mode.
7. Check colour co-ordinates "X" and "Y" at 20 a 120 Nits. It may be necessary to repeat the same procedure to
obtain the above values.
Adjustment Method 2 (using the signal generator, with a fixed picture signal)
1. Adjust G2.
2. Tune a white pattern with burst signal.
3. Operate in "Service Mode":
4. Using «SUB-CON», select a luminance of 70 nits.
5. Operate again in "Service Mode" and select «DRI-GS» and/or «DRI-BS» locations to obtain colour co-ordinates:
6. Select «SUB-CON». Return data to "63".
7. Re-set the TV with the mains switch button to store the adjustment and exit Service Mode.
8. Check colour co-ordinates "X" and "Y" at 20 a 120 Nits. It may be necessary to repeat the same procedure to
obtain the above values.
X
±
0.290
0.015
0.300
X
±
0.290
0.015
0.300
Y
Screen temperature
±
0.015
8550º K+1 MPCD
Y
Screen temperature
±
0.015
8550º K+1 MPCD
11
15JF-25S