Sharp CD-BA300 Betriebshandbuch - Seite 15

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Stereo System Sharp CD-BA300 herunter. Sharp CD-BA300 32 Seiten. Cdba300 operation manual
Auch für Sharp CD-BA300: Kurzanleitung (4 seiten)

Seite drucken
Sharp CD-BA300 Betriebshandbuch

Setting the Clock

In this example, the clock is set for the 12-hour (AM 12:00) display.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK button and within 5 seconds, press the
MEMORY/SET button.
3
Press the TUNING/TIME (X X X X X or W W W W W ) button to select the 12-hour or
24-hour display and then press the MEMORY/SET button.
"AM 12:00"
The 12-hour display will appear. (AM 12:00 - PM 11:59)
"AM 0:00"
The 12-hour display will appear. (AM 0:00 - PM 11:59)
"0:00"
The 24-hour display will appear. (0:00 - 23:59)
Note that this can only be set when the unit is first installed or it has been reset
(see page 30).
*BA300_P13_15
15
4
Press the TUNING/TIME (X X X X X or W W W W W ) button to adjust the hour and
then press the MEMORY/SET button.
Press the TUNING/TIME (X or W) button once to advance the time by 1
hour. Hold it down to advance continuously.
When the 12-hour display is selected, "AM" will change automatically to "PM".
5
Press the TUNING/TIME (X X X X X or W W W W W ) button to adjust the minutes
and then press the MEMORY/SET button.
Press the TUNING/TIME (X or W) button once to advance the time by 1
minute. Hold it down to change the time in 5-minute intervals.
The hour will not advance even if minutes advance from "59" to "00".
The clock begins counting from "0" seconds. (Seconds are not displayed.)
The time display will disappear after a few seconds.
To confirm the time display:
Press the CLOCK button.
The time display will appear for about 5 seconds.
Note:
The "CLOCK" or time will flash at the push of the CLOCK button when the AC power
supply is restored after a power failure or after unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the Clock" from the beginning.
If the time display is flashing, step 3 (for selecting the 12-hour or 24-hour display) will
be skipped.
To change the 12-hour or 24-hour display:
1. Clear all the programmed contents.
[Refer to step 3 under "If trouble occurs" on page 30 for details.]
2. Perform "Setting the Clock" from the beginning.
00.11.16, 2:49 PM
15