Sharp CD-ES222E Schnellstart-Handbuch - Seite 2
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Stereo System Sharp CD-ES222E herunter. Sharp CD-ES222E 3 Seiten. Mini component system
Auch für Sharp CD-ES222E: Betriebshandbuch (32 seiten), Schnellstart-Handbuch (2 seiten)
Seite drucken
Listening to a CD (CDs)
1
Press the CD button.
2
Press the OPEN/CLOSE
3
Place the CD(s) on the disc tray, label side up.
When loading a third disc, press the DISC SKIP button to
turn the disc tray, then place the CD in the open position.
4
Press the OPEN/CLOSE
5
To select the CD you want to listen to first, press one of the
1 -
3 buttons on the remote control.
6
Press the
Listening to the radio
1
Press the TUNER (BAND) button repeatedly to select the
desired frequency band (FM or AM).
2
Press the TUNING/TIME (
desired station.
When the TUNING/TIME button is pressed for more than 0.5
seconds, scanning will start automatically and the tuner will
stop at the first receivable broadcast station.
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display the "ST" indicator.
● " " will appear when an FM broadcast is in stereo.
Downloaded from:
http://www.usersmanualguide.com/
button to open the disc tray.
12 cm (5")
button to close the disc tray.
/
button to start playback.
or
) button to tune in to the
FM stereo mode indicator
FM stereo receiving indicator
Listening to a cassette tape
1
Open the cassette door by pushing the area marked "PUSH
EJECT
".
8 cm (3")
2
Load a cassette into the TAPE 1 compart-
ment or TAPE 2 compartment with the
side to be played facing toward you.
3
Press the TAPE (1
want to listen to.
4
Press the
/
If trouble occurs
■
When this product is subjected to strong external interference
(mechanical shock, excessive static electricity, abnormal supply
voltage due to lightning, etc.) or if it is operated incorrectly, it may
malfunction.
If such a problem occurs, do the following:
1. Set the unit to the stand-by mode and turn the power on
again.
2. If the unit is not restored in the previous operation, un-
plug and plug in the unit, and then turn the power on.
Note:
If neither operation above restores the unit, clear all the memory
by resetting it.
Clearing all the memory (reset)
■
1. Press the ON/STAND-BY button to enter the power stand-
by mode.
2. Whilst pressing down the CLOCK button and the DISC
SKIP button, press the ON/STAND-BY button until
"CLEAR" appears.
Caution:
This operation will erase all data stored in memory including clock,
timer settings, tuner preset, and CD programme.
Maintenance
■
Routine maintenance is required for continued optimum perfor-
mance, refer to the operation manual (page 28).
TAPE 1 TAPE 2
2) button to select the cassette you
button to start playback.