Sharp CD-ES770 Betriebshandbuch - Seite 26

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Stereo System Sharp CD-ES770 herunter. Sharp CD-ES770 36 Seiten. Mini component system
Auch für Sharp CD-ES770: Schnellstart-Handbuch (2 seiten), Service-Handbuch (14 seiten), Service-Handbuch (14 seiten), Service-Handbuch (14 seiten)

Seite drucken
Sharp CD-ES770 Betriebshandbuch
Recording on a cassette tape (continued)
CD-ES770
Recording from several CDs continuously:
1 Perform steps 1 - 5 in "Recording from a CD (CDs)" on page 25.
2 Within 5 seconds, press the
To perform programmed recording:
1 Program discs and tracks. (See page 20.)
2 Press the
button.
3 Press the
/
To stop recording:
Press the
(TAPE ) button.
The CD and tape will stop.
Recording from the radio
1
Tune in to the desired station. (See page 21.)
2
Load a cassette into the TAPE 2 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the
button.
Recording will be paused.
4
Press the
/
To interrupt recording:
Press the
button.
To resume recording, press the
To stop recording:
Press the
(TAPE ) button.
Note:
If you hear a whistling noise while recording an AM station, move the
AM loop antenna.
26
/
(TAPE
).
(TAPE
).
(TAPE
) button to start recording.
/
(TAPE
) button.
Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette
into the TAPE 1 cassette com-
partment. Insert a blank tape
into the TAPE 2 cassette com-
partment.
It is recommended that the recording tape is the same length as
the master tape.
3
Press the TAPE (1
2) button until "TAPE 1" appears on
the display.
4
Press the
button.
Recording will be paused.
5
Press the
/
(TAPE
To stop dubbing:
Press the
(TAPE ) button.
TAPE 1 and TAPE 2 will simultaneously stop.
Erasing recorded tapes
1 Load the tape to be erased into the TAPE 2 cassette
compartment with the side to be erased facing toward you.
2 Press the TAPE (1
2) button until "TAPE 2" appears on the
display.
3 Press the
button.
4 Press the
/
(TAPE
) button to start erasing.
Note:
Make sure that the TAPE 1 is not in use.
) button to start dubbing.