Digit Primo Gebrauchsanweisung - Seite 2

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für GPS Digit Primo herunter. Digit Primo 4 Seiten.

3.2 Battery Charging

Connect AC-DC power adapter to the Digit Primo device using the power cable.

Insert the AC-DC power adapter into the power socket.

During charging, the Power LED will flash RED slowly. When the battery is fully charged, the Power LED will flash GREEN slowly.

The charging process will last about 5 hours depending on battery condition.

Note: Before using the Digit Primo device for the first time please make sure that the battery is fully charged, which will make the life of

the battery much longer.

3.3 Digit Primo charging cable

Use with the power adaptor supplied with the kit

Can also be used to charge the device from your PC using a USB plug.

NB! The Digit Primo will not log trips while being charged!

3.4 SIM card

Step1: Pull open the cover of SIM card slot.

Step2: Insert the SIM card into the slot according to the direction as shown

Step3: Push the cover back.

3.4 Power on/Power off

Power ON - Press the Power key for at least 2 seconds, then release to power ON the device. Note that, the Power LED green light will

flash fast while the device boots up.

Power OFF - Press the power key for about 3 seconds: Power LED red light will flash fast and then turn off, which indicates that Digit

Primo has shut down and has been powered off.

Note: The user cannot power off the device if the power key is disabled by protocol.

3.5 Adding to the server

Please add the Digit Primo to your server in the same way you add a new vehicle. (Your service provider might do this for you.)

3.6 Adding the Primo to your software is done in the same way you add a vehicle. Remember to NOT check the trip ignition I/O box

otherwise you will not get any trip history. Also remember to adjust the small trip filters to accommodate the type of usage.

4.Trouble-shooting and Safety information

4.1 Trouble-shooting

Problem

Messages can't be reported to the

Digit server by GPRS.

Unable to power off the device

Battery cannot be charged

The device can't fix a GPS signal

successfully. GPS LED flashes

slowly.

4.2 Safety info



Do not disassemble the device. (The warranty will be void.)



Do not place the device in extremely high temperatures as this can cause overheating. Avoid exposure to direct sunlight. Too high

temperatures will damage the device or even cause the battery to explode.



Please do not use Digit Primo on an airplane or near medical equipment.

Possible Reason

The SIM card in Device doesn't support GPRS.

APN is wrong. Some APN cannot visit the internet

directly.

The IP address or port of the backend server is

wrong.

The function of power key was disabled by

AT+GTFKS.

The battery has not been used for too long time and

has been locked

The GPS signal is weak.

Solution

Try a GPRS supported SIM card.

Ask the network operator for the right APN.

Make sure the IP address for the backend server is an identified

address on the internet.

Enable the function of power key by AT+GTFKS.

Using an external power source with 3.6V to 4.2V DC power supply

to active the battery or apply for after sales help.

Please move the Digit Primo to a place with open sky.

Let the front of the device face to the sky. (The same surface as the

LED panel)