Sharp AR-M350 Imager Betriebshandbuch - Seite 26

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Alles in einem Drucker Sharp AR-M350 Imager herunter. Sharp AR-M350 Imager 40 Seiten. Ar-m280 | ar-m350 | ar-m450 operation manual (for network scanning)
Auch für Sharp AR-M350 Imager: Broschüre & Specs (11 seiten), Teile-Handbuch (30 seiten), Betriebshandbuch (32 seiten), Handbuch zum Nachfüllen (8 seiten)

Seite drucken

SPECIAL FUNCTIONS

Job build

The number of originals that can be copied into a set of copies in a single run is limited by the capacity of the memory

available*

for scanned originals. Normally the number of originals is further limited by the number of originals that can

be set into the document feeder tray*

The job build function allows scanning and copying of up to 100 originals. For scanning more than 50 originals, the

originals must be separated into sections not exceeding 50 originals, scanned in sections and stored in memory. After

all sections are in memory, they can be copied as a continuous set .

*1 The number of originals that can be copied into a set of copies in a single run is limited by the capacity of the

memory available for scanned originals.

*2 Up to 50 sheets (30 sheets for 8-1/2" x 14" or larger) can be set into the document feeder tray at one time.

[Example] Copying 100 pages of 8-1/2" x 11" or A4 originals

Originals

Page 1

Page 51

50 sheets

✽

Divide the originals in sections of 50 sheets and scan

the originals starting from the first page of section A and

then scan section B. Be sure to keep the correct page

order when setting section B.

Touch the [JOB BUILD] key on the SPECIAL

MODES screen.

JOB BUILD

Touch the [OK] key on the special modes screen

while JOB BUILD is highlighted.

DUAL PAGE

ERASE

COPY

JOB BUILD

MULTI SHOT

Place the first section originals in the document

feeder tray. (page 7)

The [JOB BUILD] key will be

highlighted.

Make all other desired settings such as the

number of copies, and press the [START] key.

Touch the [READ-END] key after the last section

of originals has been scanned.

PLACE NEXT ORIGINAL. PRESS [START].

WHEN FINISHED, PRESS [READ-END].

READ-END

To cancel the job build function, touch the [JOB BUILD]

key on the special modes screen as in step 1. The

highlighted display will be canceled.

Scanning of originals will

start. After scanning of the

first section of originals ("A

in the example above) is

completed, remove the

scanned originals, place the

next section of originals

(section B in the example)

and press the [START] key.

Repeat this operation until

all blocks of originals have

been scanned.