Digit-KD VISION series Gebrauchsanweisung - Seite 3

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Tastenfeld Digit-KD VISION series herunter. Digit-KD VISION series 12 Seiten. Remote keypad with lcd display

3.0. BUTTONS AND INDICATORS

Optical
indicators
UNIT ON
T AMPER
FIRE
LOW BAT.
TES T
Display
LCD
Digit-KD
Not used
On the left of the keypad are present the following optical signalling with LED indications:
UNIT ON
Control panel armed in Day and Night mode.
- Flashes quickly during exit time, then will light until the control panel is disarmed.
- If the option 8 is active (see VISION instructions) and when you arm the control panel
there is an open line or the control panel's battery is low, the LED flashes slowly during
exit time and then will light until the control panel is disarmed.
- If the option 8 is not active, the LED flashes slowly for a few seconds, then will go "off".
The control panel does not arm when this takes place.
TAMPER
Tamper alarm
- In Maintenance mode, the LED will light for the time that the line remains unbalanced.
- In Programming mode, the LED will light during the keychain transmitters programming
and flashes quickly during zone configuration (immediate/delayed).
- With the control panel armed in (Day or Night mode) or disarmed, if a tamper alarm is
triggered the LED flashes slowly until the control panel is re-armed.
FIRE
Fire alarm
- In Maintenance mode, this LED will light for the time that the line remains unbalanced.
- In Programming mode, the LED will light during the wireless sensor programming and
flashes quickly during the association of the zones to the Night group.
- With the control panel armed in (Day or Night mode) or disarmed, if a fire alarm is
triggered the LED flashes slowly until the control panel is re-armed.
LOW BAT.
Low battery
- In Maintenance mode, the LED will light to signal low battery of the control panel and of
wireless sensor (every time the sensor triggers an alarm).
- In programming mode, the LED will light during the electronic keys or remote keypads
learning process and flashes quickly during the zone configuration (NC or balanced).
- With the control panel disarmed, armed and Test control mode, the LED flashes slowly
to signal low battery of the control panel, and will flashes quickly to signal low battery of
the wireless sensor. The signalling will remain active until the control panel is re-armed.
TEST
Test-control
- In Maintenance mode, the LED flashes slowly.
- In Programming mode, the LED flashes quickly during all phases.
- The LED will light while by-passing zones and Test-control arming mode.
Digit-KD instruction manual
The buttons from 0 to 9 are used
to digit access code
Button for confirmation
ENGLISH
Buttons used to visualize or for
running menu (*)
Forward
Backward
Button for arming in Night
and Test-Control modes
Button to
by-pass zones
Pag. 3