Sharp SJ-14T-H2 Betriebshandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Kühlschrank Sharp SJ-14T-H2 herunter. Sharp SJ-14T-H2 8 Seiten.

Seite drucken

STORING FOOD

Refrigeration reduces the rate of food spoilage. To

maximize the shelf life of perishable food products,

ensure that the food is of the freshest possible qual-

ity. The following is a general guide to help promote

longer food storage.

Fruit / Vegetables

To minimize moisture loss, fruit and vegetables should

be loosely enclosed in a plastic material e.g. wrap,

bags ( do not seal ) and place in the Vegetable crisper.

Those fruits and vegetables with thick skins e.g. or-

anges do not require wrapping.

Dairy Products & Eggs

• Most dairy products have a use by date on the outer

packaging which informs the recommended tem-

perature and shelf life of the product.

• Eggs should be stored in the Egg tray.

CARE AND CLEANING

Some household cleaning chemicals may affect the

inside surfaces and plastic shelves resulting in split-

ting or cracks occurring.

When cleaning all plastic parts

inside this refrigerator, only use

diluted dishwashing liquid

(soapy water). Make sure that

all plastic parts are thoroughly

rinsed with water after cleaning.

1.Remove the shelves and pockets from the cabinet

and door. Wash them in warm soapy dishwashing

water; rinse in clean water and dry.

2.Clean the inside with a cloth soaked in warm soapy

dishwashing water. Then, use cold water to wipe

off soapy water.

3.Wipe the exterior with a soft cloth each time it is

soiled.

4.Clean the Magnetic door seal with a toothbrush and

warm soapy dishwashing water.

5.Whenever the refrigerator is moved to clean or re-

positioned, Evaporating pan should be removed and

cleaned.

NOTE:

• Do not use polishing powder, benzine, hot water etc.

• If undiluted detergent is used or soapy water is not

wiped off thoroughly, cracking of plastic parts can

result.

• Wipe any food oils adhered to plastic components

as they can cause cracking of the plastic surface.

WHAT TO DO BEFORE YOU CALL FOR SERVICE

Before you call for service, check the following point .

IT IS NORMAL

for the refrigerator to produce the

following sounds.

• Loud noise produced by the compressor when op-

eration starts --- Sound becomes quieter after a while.

• Loud noise produced once a day by the compressor

--- Operating sound produced immediately after au-

tomatic defrost operation.

• Sound of flowing fluid (gurgling sound, fizzing sound)

--- Sound of refrigerant flowing in pipes (sound may

become louder from time to time).

Meats / Fish / Poultry

• Place on a plate or dish and cover with paper or plastic wrap.

• For larger cuts of meat, fish, or poultry, place to the rear of the

shelves.

• Ensure all cooked food is wrapped securely or placed in an

airtight container.

NOTE:

• Evenly place the food on the shelves to allow the cooling air to

circulate efficiently.

• Hot foods should be cooled before storing. Storing hot foods

increases the temperature in the unit and increases the risk of

food spoilage.

FOR BEST FREEZING

• Quality of foods should be fresh.

• Food should be properly stored or covered and the air should

be removed to seal tightly.

• Evenly place the food in the freezer.

• Label bags or containers to keep an inventory of freezing food.

Evaporating pan;

How to remove

Move Evaporating pan to

pull it toward yourself.

How to set

Set Evaporating pan so that

the two protrusions come

through its corresponding

holes.

Replacing the lamp bulb

Replace lamp bulb with same type.

Refrigerator: base E12, MAX 10W, T-20.

Make sure that the rated voltage and wattage of the lamp bulb

are correct when replacing (check the label near the bulb).

When replacing the lamp bulb, unplug the refrigerator first to pre-

vent electric shock.

Switching off your refrigerator

If you switch your refrigerator off when you are going away for an

extended period, remove all food, clean the interior thoroughly.

Remove the power cord plug from the power socket and leave

all doors open.

• Cracking or crunching sound --- Sound produced by expan-

sion and contraction of inner walls and internal parts during

cooling.

• Squeaking sound --- Sound produced by expansion and con-

traction of internal parts.

IT IS NORMAL

that the outside of a cabinet may be hot when

touched. The hot pipe is in the cabinet in order to prevent dew

generation.

IF YOU STILL REQUIRE SERVICE

Refer to your nearest service agent approved by SHARP.

Evaporating Pan