Sharp Conference Series XG-PH80W-N Setup-Handbuch - Seite 24
Blättern Sie online oder laden Sie pdf Setup-Handbuch für Projektor Sharp Conference Series XG-PH80W-N herunter. Sharp Conference Series XG-PH80W-N 32 Seiten. Projectors
Auch für Sharp Conference Series XG-PH80W-N: Broschüre & Specs (4 seiten), Spezifikationsblatt (4 seiten), Spezifikationen (2 seiten)
Seite drucken
Controlling the Projector via LAN
After connecting the projector to your network, enter the projector IP address in
"Address" on Internet Explorer (version 6.0 or later) using a computer on the network to
start a setup screen that will enable control of the projector via the network.
Controlling the Projector
Using Internet Explorer
Complete connections to external
equipment before starting the operation.
(See pages 21-25 of the projector's
operation manual.)
Complete the AC cord connection. (See
page 27 of the projector's operation
manual.)
Note
•
Set "LAN/RS232C" in "Ex. Setting" of the
"PRJ-ADJ" menu to "LAN".
•
When connecting the projector to the LAN, use
a commercially available LAN cable (UTP cable,
Category 5, cross-over type). When
connecting the projector to a hub, use a
straight-through cable.
1
1
Start Internet Explorer on the
computer.
2
2
Enter "http://" followed by the
projector IP address set by the
procedure on page
"/" in "Address", and then press
the "Enter" key.
•
When "DHCP Client" is set to "Off" on the
projector, IP address is 192.168.150.2. If you
did not change the IP address in "3. Setting
up a Network Connection for the
Projector" (pages 22-23), enter
"http://192.168.150.2/system.html".
3
3
A screen for controlling the
projector appears, ready for
performing various status
conditions and control.
-24
22
followed by