Shimano BR-M6000 Handbuch für Händler - Seite 33
Blättern Sie online oder laden Sie pdf Handbuch für Händler für Zubehör für Fahrräder Shimano BR-M6000 herunter. Shimano BR-M6000 39 Seiten. Hydraulic disc brake
Auch für Shimano BR-M6000: Handbuch für Händler (39 seiten)
Seite drucken
- 1. Table of Contents
- 1. Important Notice
- 2. To Ensure Safety
- 3. List of Tools to be Used
- 4. Installation
- 4. Disc Brake Mount Adapter (for 180Mm Disc Brake Rotors)
- 4. Disc Brake Rotor Adapter
- 4. Brake Hose
- 5. Maintenance
- 5. Adding Shimano Genuine Mineral Oil and Bleeding Air
- 5. Replacing the Brake Hose
- 5. Replacing the Brake Pads
MAINTENANCE
Replacing the brake hose
Caliper side (BL-M6000/BR-M6000/BR-MT500/BL-MT500)
The illustration uses BR-MT500/BL-MT500 as an example to explain.
1
(A)
2
(z)
(A)
(B) (C)
(y)
(z)
3
To be continued on next page
Use a utility knife or other cutting tool
to cut the brake hose.
(z)
(z)
In order to check that the ends of the
(A)
brake hose are fitted securely into the
base of the brake hose mounts of the
brake calipers and brake lever, make
marks on the brake hose beforehand as
shown in the illustration.
(As a guide, the length of brake hose
inside the mount should be
approximately 14mm, measured from
the cut end of the brake hose.)
(z)
Pass the brake hose through the
(D)
connecting bolt and olive, as shown in
the illustration.
(y)
(z)
(E)
(C)
90°
Approx. 14mm
Direction of insertion
Grease the outside of the olive.
33
NOTE
Use the utility knife safely and correctly in
accordance with its instruction manual.
TECH TIPS
If you are using TL-BH62, refer to the manual
accompanying the product.
(A)
Mark
(A)
Brake hose
(B)
Connecting bolt
(C)
Olive
(D)
Cut end
(E)
Grease
NOTE
For installation to the built-in type frame, first
connect to the frame caliper the end of the
brake hose to which the banjo is not
attached.