Shimano EW-EX010 Handbuch für Händler - Seite 17
Blättern Sie online oder laden Sie pdf Handbuch für Händler für Zubehör für Fahrräder Shimano EW-EX010 herunter. Shimano EW-EX010 19 Seiten. Ew-jc200
Seite drucken
TROUBLESHOOTING
Error Code
TROUBLESHOOTING
Error Code
When the following error codes are displayed on the BOSCH display, refer to the table below.
Code
ID700
The DI2 Adapter B may have malfunctioned.
The BOSCH eBike Drive Unit is not compatible with the DI2
ID720
Adapter B.
ID724
Rear shifting system adjustment has failed.
The SEIS* which is not compatible with the DI2 Adapter B may
ID725
be currently connected.
ID726
The SEIS* shifting unit of DI2 may not be properly connected.
ID727
The DI2 shifting switch may not be properly connected.
ID729
An assist switch compatible with SHIMANO STEPS is connected.
ID799
The BOSCH eBike Drive Unit software version is not supported.
* SEIS: SHIMANO ELECTRONIC INTELLIGENT SYSTEM
* If there is a malfunction, but the error code is not displayed on the BOSCH display, use E-TUBE PROJECT or a BOSCH diagnosis tool to investigate in
greater detail.
Details
17
Action needed
1. Turn on the power again.
2. E-TUBE PROJECT Error Check in single part condition.
3. Replace DI2 Adapter B.
* If the situation does not improve, the DI2 Adapter B might
be damaged. Consult an agency.
Check the BOSCH eBike Drive Unit.
Refer to "Compatibility Chart" on page 6. Or consult an
agency.
1. If the rear derailleur is connected, check the adjustment bolt
and adjust its tightness.
2. Check the product related to the gear shift alone with
E-TUBE PROJECT.
* If the situation does not improve, electric wire might be
damaged. Consult an agency.
• Check the SEIS* compatibility chart.
If a product not on the SEIS* compatibility chart has been
connected, remove or exchange it for a compatible product.
* Other models may also be compatible with the DI2 Adapter
B by updating the firmware; update all the connected SEIS*
firmware via E-TUBE PROJECT to the latest version.
1. Turn off the power and check if the electric wire is correctly
connected. Then turn on the power again.
2. Check the product related to the gear shift alone with
E-TUBE PROJECT.
* If the situation does not improve, the electric wire might be
damaged.
Consult an agency.
1. Turn off the power and check if the electric wire is correctly
connected. Then turn on the power again.
2. Check the shift switch of DI2 alone with E-TUBE PROJECT.
* If the situation does not improve, the electric wire might be
damaged. Consult an agency.
This switch doesn't work with the DI2 Adapter B. Change the
switch mode from assist mode switch to gear shifting switch
with E-TUBE PROJECT.
Update to a supported BOSCH eBike Drive Unit version of the
software.