Shimano Ultegra 6770 Series Handbücher - Seite 13

Blättern Sie online oder laden Sie pdf Handbücher für Fahrrad Shimano Ultegra 6770 Series herunter. Shimano Ultegra 6770 Series 24 Seiten.

$ Front junction: Connection of junction (A)

When routing the SM-EW67-A-E, allow enough looseness in the cable

so that the ST-6770 installation position can be adjusted and so that

the handlebars can be turned fully to the left and right. When

routing the electric wires, they can be wrapped around the

handlebars when wrapping the handlebar tape.

(Sample connection diagram for ST-6770 and SM-EW67-A-E)

$ Connection to the Dual control lever

Use the TL-EW02 special tool to connect to the ST-6770. Set so that the projection on the

connector is aligned with the groove on the narrow end.

Open up the bracket cover and lift up the connector cover.

Use the TL-EW02 to connect the connector of the electric wire to the

terminal on the lever side. Be sure to push them together until they

connect with a click. Either the top or bottom terminal can be used.

Use the accessory cable ties to secure junction (A) to the outer

casing of the brake cable.

* The remaining terminal can be used for an additional

satellite switch or the SM-PCE1.

$ Installation of the battery mount

Set the battery mount into position. Use the bottle cage fixing bolt to provisionally install the battery mount to the bottom of

the bottle cage.

Use the bolts which are included with the bottle cage to secure

the SM-BMR1-L (long type).

Refer to the Service Instructions for the bottle cage for details

on the tightening torques.

Leave a space of 108 mm or more at the end of the battery

mount. Check that the battery can be inserted and removed

while the bottle cage is installed.

Tighten the bolt of the bottle cage to secure the battery

mount. For the SM-BMR1-L (long type), use the accessory

cable tie to secure the battery mount to the frame.

* If there is a mounting boss on the frame, the battery

mount can be secured to the frame with a bolt.

2mm Allen key

Tightening torque:

1.2 - 1.5 N·m {10.4 - 13 in. lbs.}

Use the included M4 bolts to secure the SM-BMR1-S

(short type).

Tightening torque:

1.2 - 1.5 N·m {10.4 - 13 in. lbs.}

Cable tie

Battery mount fixing bolt

(M4 x 15mm)

Tightening torque:

1.2 - 1.5 N·m {10.4 - 13 in. lbs.}