Accutone Mercury Series Benutzerhandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kopfhörer Accutone Mercury Series herunter. Accutone Mercury Series 6 Seiten.

Seite drucken

Charging Battery.

Ž Connect the other end of the cable (smaller micro-USB end) to the

Port

on the headset, make sure it's completed inserted firmly.

The

(B)headset LED

next to the port will light up immediately. (If not, please

check the power adaptor is connected to a wall-jack or the computer is powered on).

LED will remains RED when charging. It will turn BLUE when fully charged. To

avoid using the Mercury during charge, the unit will not operate once connected to a

power source.

Pairing Mode.

Check and make sure your device, be it computer,

tablet or mobile phone supports bluetooth.

Place your mobile phone / tablet / computer for pairing close

to Mercury, within 1 meter distance.

Turn on bluetooth pairing / searching mode on your device.

Ž Make sure Mercury is turned off*, and press and hold the

Multifunction Button

for more than 5 seconds until the

headset LED

(as shown in above section) flashes blue and red.

Go to your pairing device and look for "Mercury" under the

bluetooth searched list, and select connect.

When successfully paired, the

(B) headset LED

and flash.

Note that Mercury doesn't come with a power

adaptor, but it can be charged via any standard

USB-Power adaptor or USB ports on computers.

Œ Connect the supplied cable's normal USB

connector (bigger end) to any standard USB-

Power adaptor or any computer's USB port

(make sure the computer is powered on).

Open up the lid on the RIGHT side of the

headset, you will notice a small chamfer on the

lid. (As the illustration on the left)

(A)Charging

(C)

(B)

will turn blue

Pairing Mode.

* If you released the

Mercury enters pairing mode or if Mercury keeps on flashing only blue after you've

press and hold the button for more than 5 seconds, it means that it is still connected

to another device and operating.

You will need to turn off the device, by pressing the same button for two seconds

and release the button. If the

(B) headset LED

indicates Mercury has powered down. Repeat step 3 on the previous page for

pairing.

** On some pairing devices, a Pin Code is required for bluetooth pairing, simply

input "0000" (four zeros) when requested.

Wearing Method.

While Mercury is designed to fit most users ear sizes, with it's three sizes of silicon

sleeves and memory foam, some users prefer a firmer, stabler hold. Simply add the

stabilizer rings

as below:

Make sure you wear your Mercury according to the Left/Right markings on the

headset, and

the cable should always be rested behind your neck.

Memory Foam.

Before inserting a memory foam

earbud in your ear, squeeze and gently

twist it to the smallest size, and allow it

to slowly regain its form inside your ear.

Once the foam regain its size (about 10

seconds), it will have molded with the

shape of your ear canal to a perfect fit.

(less than 5 seconds) before

turns red for a few seconds, this

Œ Remove the existing silicon or memory

foam earbud.

Insert the stabilizer ring between the

nozzle and the earbud.

Ž Rotate the stabilizer ring to find the

perfect angle for firm hold to your ear.