Crestron IRP2 Installationshandbuch - Seite 7
Blättern Sie online oder laden Sie pdf Installationshandbuch für Kontrollsysteme Crestron IRP2 herunter. Crestron IRP2 12 Seiten. Ir emitter probe
Auch für Crestron IRP2: Installationshandbuch (2 seiten), Installationshandbuch (2 seiten)
Seite drucken
Crestron IRP2
IR Mask Installation
The IR mask (supplied) is designed to fit over the IRP2 shell, as shown in
the following illustration, so that the sensor window of the controlled
component is completely covered. The IR mask prevents unwanted
external IR signals from passing through or leaking past it. The IR mask
also prevents emitting IR from the IRP2 shell from radiating backward
into the IR sensors of other nearby components.
1. Without removing the adhesive backing from the IR mask, fit the two
pieces together and accurately position them over the IR sensor
window of the component to be controlled.
2. Attach the IRP2 to the sensor window using transparent silicon
adhesive (not supplied). Temporarily tape the IRP2 in place using non-
damaging tape until the silicon cures.
3. If necessary, neatly trim the IR mask. Be sure that it overlaps the
margins of the component IR sensor window.
4. Remove the adhesive backing from the IR mask and position it over
the IR sensor window while pressing down firmly.
Attach the IRP2 to Other Locations
Rather than affixing the low output side of the IRP2 shell directly over the
IR sensor window, the shell can be positioned as much as three feet away
on the axis of the IR sensor window. The high output side of the IRP2
Installation Guide - DOC. 8168A
Infrared Emitter
Infrared Emitter • 3