Accutone ASP2200 Benutzerhandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Accutone ASP2200 herunter. Accutone ASP2200 5 Seiten. Telephone amplifier

33.c) Headset Hanger Installation

You will find the following 3 parts (see image right) packaged with your Accutone Amplifier.

One plastic and 2 metal parts that form the headset hanger.

To set up your headset hanger insert the piece (I) first into the bottom of the TM220

Amplifier as illustrated right, make sure that it is correctly inserted into the track, you will

feel a 'click', which means that it is inserted correctly. Then gently turn the metal piece

inwards towards the amplifier so that the entire piece is fastened to the bottom, as shown

on the right.

Upon completion of the above attach the remaining metal piece (II) to the plastic piece (III)

as shown on the right. Make sure that the hanging hook (A) and the cord winders (B) are

facing opposite in opposite directions.

The hanging hook (A) is where you hang your headset and the and the cable tidy (B) is

designed for winding your headset cord around.

The final step is to place the assembled pieces (II) & (III) into the already installed metal

base (I) which is fastened to the bottom of your amplifier. To do this, gently insert the

metal rods (I) into the holes at the bottom of the plastic piece (III).

33.d) Connecting your headset

The ASP2200 amplifier allows you to use any of the Accutone Telephone headsets.

Plug in your telephone headset to the RJ-11 socket marked for the telephone headset (16) on the front of the ASP2200 amplifier.

3.e) Power

Your ASP2200 requires power to operate correctly, it can be powered by either 2 x AA sized batteries (not supplied) or a mains adapter

(optional extra). To open the battery compartment, slightly depress the compartment lid (4) and slide it outwards. Install batteries with

polarities according to the battery diagram inside the compartment. Close the lid and turn the power "ON". Alkaline batteries are

recommended.

3.f) Configure the Control Unit

The 6-position telephone configuration switch (7) on the side panel allows you to select the

proper setting to ensure that your unit will work with your telephone. The switch has 6

Before your start make sure you turn down the

positions, which are (1 - 2 - 3 - 4 - 5 - 6).

volume to protect your hearing.

Put the headset over your head and switch the

Headset/Handset Switch (17) to the headset position (as shown on the right). Now select

each of the positions on configuration switch until you can hear a clear dial tone.

If you hear a clear dial tone, then your connection is working.

Note: that there may be 2 matching settings, choose the clearer setting or either one if both

perform the same.

Please Follow the Instructions in This Manual to Ensure Successful Operation of Your Headset.

Helpline 0871 200 2276