Digital Design M1c Benutzerhandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Digital Design M1c herunter. Digital Design M1c 12 Seiten. High performance digital amplifier
Seite drucken
Connect the power cables to power terminal labeled as + 12V.
all M&S-Class amplifiers are equipped with fuses so you have to install the external fuses on
the power cable.
Connect one end of fuse holder to the power cable and the other end of fuse holder
to positive battery within 20 cm of the same cable.
This fuse location will protect the system and the vehicle against the possibility of a short circuit in
the power cable. Be sure to use fuses and fuse holder adequate for the application.
GND (GROUND CONNECTION )
Locate a secure grounding connection as close to amplifier as possible.
Make sure the location is clean and provides a direct electrical connection to the frame of the vehicle.
Connect one end of a short piece of the same size cable as the power cable to the grounding point.
Run the one end of the cable to the grounding point.
Run the other end of the cable to the mounting location
Connect the ground cable to the screw terminal labeled as GND.
REM ( REMOTE CONNECTION )
Run a remote turn on cable from the switched + I2V source .
you will be using to turn on the system components.
This may be a toggle switch, a relay, or your source unit's remote trigger cables, or power antenna
trigger cable. Connect the remote turn on cable to the power terminal labeled as REM.