Digital Devices Cine C/T Handbuch zur Schnellinstallation - Seite 3
Blättern Sie online oder laden Sie pdf Handbuch zur Schnellinstallation für Aufnahmegeräte Digital Devices Cine C/T herunter. Digital Devices Cine C/T 8 Seiten.
Seite druckenENGLISH
1. Safety Considerations
The enclosed CD contains an detailed installation instructions. Follow the
installation instructions for PC cards in the manual of your PC.
2. Operating Safety
• The TV card should be installed by a properly qualified technician or a
person with relevant knowledge and expertise.
• Before installing the TV card, disconnect the PC from the mains power
supply. Failure to do so could lead to serious injury and/or damage.
• This TV card is intended only for use in a PC and to be powered via PCI
Express bus.
• The guidelines for electromagnetic compatibility (EMC) must be
observed at all times when connecting the TV card. Electrostatic
discharge (ESD) can damage the internal components of a PC. Use an
anti-static wrist strap or maintain constant physical contact with a
highly conductive metal body.
• No liability will be accepted for damage caused by ESD as a result of
improper handling.
•
Always make a backup copy of your data on a suitable external storage
medium (CD, floppy, Zip etc.) before installation. Claims for damages in
respect of lost data and consequential losses arising from lost data will
not be accepted.
3. Installation of the TV card / Bridge
(Please refer to the illustrations on page 6,7 + 8)
• Unscrew and carefully remove the PC cover to gain access to the
inside.
• Unscrew the blank slot bracket from a free PCIe slot and remove it.
• 2 slot brackets (full height & low profile) are enclosed in the package.
• Carefully screw the appropriate slot bracket for your PC to the TV card.
•
Holding the TV card carefully by its edges, position it vertically over a
free PCIe slot (x1 up to x16) and insert it into the slot. Avoid touching
the golden finger of the TV card and do not damage any internal
components.
• Push the TV card into the slot from above, so that the TV card snaps
into position in the slot
• Screw the slot bracket of the TV card to the PC chassis.
•
Connect a standard 4 pin floppy power connector (to power the LNB) to
the connector at the rear of the TV card. (only Cine S2)
• Replace the PC cover and reconnect all cables.
• Connect the mains power cable to the PC and switch on the PC.
• Finally, install the enclosed software driver.
• After the restart you can configure the TV card in Windows® Media
Center or an alternative software TV program.
Installationsanleitung 05/2012 Digital Devices GmbH®
Seite 3 / 8