Digital Electronics Corporation PL-3600T Series Installationshandbuch - Seite 12

Blättern Sie online oder laden Sie pdf Installationshandbuch für Industrie-PC Digital Electronics Corporation PL-3600T Series herunter. Digital Electronics Corporation PL-3600T Series 19 Seiten.

Seite drucken

Unit:mm[in.]

295.5

PL-3600T

-0

+0.04

Series

[11.61

-0

(2) Confirm that the installation gasket is

attached to the PL unit and then place the

PL unit into the panel from the front.

• It is strongly recommended that you

use the installation gasket, since it

absorbs vibration in addition to repel-

ling water.

For the procedure for attaching the

installation gasket, refer to "PL3000

Series Hardware Manual".

(3) Insert each fastener's hook into the slot

and tighten it with a screwdriver. Tighten

the 4 screws gradually in an even, criss-

cross pattern.

Insertion Slots

Panel

Installation Fastener

Hook

Under

Panel

4-R3[0.12]

thickness

Panel

thickness

243.5

1.6[0.06] to

-0

+0.04

10.0[0.39]

]

[9.59

]

-0

Tighten against

the board.

• Tightening the screws with too much

force can damage the PL unit.

• The torque required to tighten these

screws is 0.8 N•m.

Installation/uninstallation of the

front module and the control box

• To avoid an electric shock, prior to instal-

lation/uninstallation of the front module

and the control box, confirm that the PL

unit's power supply is completely turned

OFF, via a breaker, or similar unit.

Uninstalling the front module and

the control box

(1) Unscrew the three attachment screws to

detach the cover for the flexible cable.

Flexible Cable

Cover

(2) Disconnect the flexible cable.

Flexible Cable