Bitstream HYPERION-300 Schnellstart-Handbuch - Seite 6
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Schalter Bitstream HYPERION-300 herunter. Bitstream HYPERION-300 7 Seiten. Gigabit ethernet industrial switch
Auch für Bitstream HYPERION-300: Handbuch (8 seiten)
Seite drucken
Quick start manual, a detailed manual is on the enclosed CD
6
M
ANAGEMENT
Management of the device applies HTTP and SNMP protocols, and it is possible through any
Ethernet port of the device. Additionally, access to some of the device's parameters is available
through SSH or console USB. Drivers console CLI accessible via the USB port located on the CD
included with the device.
Note!!!: In the indicated models of switches, the firmware update from a version older than:
HYPERION-105 – v120
HYPERION-300 – v120
HYPERION-303 – v120
HYPERION-200 – v308
HYPERION-400 – v308
HYPERION-500 – v308
This will remove passwords for users existing in the configuration (including the "admin"
user).
After the upgrade, the password for each user will be blank the first time they attempt to log
in to management via WWW or CLI.
In case of the firmware is downgraded to a version lower than the one indicated above, the
users will be completely removed and a default user "admin" will be created with no
password – empty.
7
E
MERGENCY RESTORING ACCESS TO THE DEVICE
There is a mechanism for generating a temporary password to access via www or telnet or CLI.
If you enter the password incorrectly via telnet or CLI 5 times or by entering the %bitstream% com-
mand in the password field, a temporary code will be generated. The code should be sent to Bit-
Stream support available from 8:00 to 16:00 at 817438643 ext. 28 or by e-mail:
stream.pl
to receive a temporary 6-hour password to access your device.
If you do not have access to the device management (wrongly entered vlan parameters, etc.),
you can restore the default configuration with the "DEF" button. Holding down the "DEF" button for
5 seconds will delete the configuration without losing the IP address, while holding down the button
for more than 10 seconds will restore the configuration to factory settings.
8
C
ONFORMITY TO STANDARDS AND RECOMMNEDATIONS
BITSTREAM devices were designed pursuant to obligatory standards and recommendations
in respect of the range of data transmission, electromagnetic compatibility and service safety.
8.1
The device was designed pursuant to the standard EN 55022, EN-55024. BITSTREAM devices
are designated to functioning in closed premises.
Notice: This device is a class A device. In the residential environment may cause radio frequency in -
terference. In such cases, you can require the user to take appropriate measures.
8.2
In respect to safety of service, BITSTREAM devices were designed and tested for operation
safety along with the EN 60950 standard.
Configuration and installation of the device should be executed by authorised persons familiar
with the service manual. The producer shall not be responsible for any occurrence that could result
from usage and installation that might not conform to this manual.
8.3
The following norms and recommendations determine the functions of data transmission and
communication interface parameters of the device.
REV.
V1.12
Electromagnetic compatibility
Safety
Data transmission
SHORT USER MANUAL HYPERION-30x
support@bit-
20 21.03.31
6/7