Siemens SIMATIC ET 200SP HA Handbuch Ausrüstung - Seite 17

Blättern Sie online oder laden Sie pdf Handbuch Ausrüstung für Industrielle Ausrüstung Siemens SIMATIC ET 200SP HA herunter. Siemens SIMATIC ET 200SP HA 44 Seiten. Distributed i/o devices busadapter for distributed i/o
Auch für Siemens SIMATIC ET 200SP HA: Handbuch (32 seiten), Handbuch (50 seiten), Handbuch (34 seiten), Handbuch (38 seiten), Handbuch Ausrüstung (50 seiten), Handbuch Ausrüstung (38 seiten), Handbuch Ausrüstung (46 seiten), Handbuch Ausrüstung (42 seiten), Handbuch Ausrüstung (44 seiten), Handbuch Ausrüstung (36 seiten), Handbuch Ausrüstung (38 seiten)

1. Install the FC cable to the BusAdapter.

2. Plug in the BusAdapter and screw it tight.

3. Secure the PROFINET IO cable to protect the plug from pulling.

Installing BusAdapter BA 2×FC

Note

The figure below is a basic representation using the ET 200SP HA as an example; it is also valid

for other distributed I/O devices.

①

②

③

④

Figure 4-3

Note

Configuration guidelines for modules with PROFINET IO interfaces

Only when all connected nodes are equipped with a SELV/PELV power supply (or have

equivalent protection) is it permitted to operate the modules with PROFINET IO interfaces in

LANs (Local Area Networks).

A data transfer point is prescribed for connection to the WAN (Wide Area Network) that

guarantees this degree of safety.

Additional information

● System manual "SIMATIC NET; Industrial Ethernet / PROFINET; Passive Network

Components (https://support.industry.siemens.com/cs/ww/en/view/84922825)"

● Pin assignment of the FC outlet (4-pin connector) (Page 32)

BusAdapter for Distributed I/O

Equipment Manual, 09/2019, A5E39261458-AB

BusAdapter BA 2×FC

FC connection element

PROFINET IO cable

Interface module

Connecting a PROFINET IO cable to the device via BusAdapter BA 2×FC

Installation

4.3 BusAdapter BA 2xFC