Siemens SIMATIC NET Installationshandbuch - Seite 12

Blättern Sie online oder laden Sie pdf Installationshandbuch für Industrielle Ausrüstung Siemens SIMATIC NET herunter. Siemens SIMATIC NET 48 Seiten. Network components bus terminal
Auch für Siemens SIMATIC NET: Betriebsanleitung (29 seiten), Betriebsanleitung (50 seiten), Betriebsanleitung (28 seiten), Montageanleitung Handbuch (6 seiten), Informationen zum Produkt (6 seiten), Installationshandbuch (40 seiten), Installationshandbuch (50 seiten), Installationshandbuch (40 seiten), Referenzhandbuch (14 seiten), Installationshandbuch (34 seiten), Betriebsanleitung (32 seiten)

1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM M2100F:

AC power cord (16 AWG)

CAT-5 Ethernet cables

Flathead screwdriver

Phillips screwdriver

4 x #8-32 screws

1.4

Proper decommissioning and disposal of this device is important to prevent malicious

users from obtaining proprietary information and to protect the environment.

Decommissioning

This device may include sensitive, proprietary data. Before taking the device out of

service, either permanently or for maintenance by a third-party, make sure it has

been fully decommissioned.

For more information, refer to the associated "Configuration Manual".

Recycling and Disposal

For environmentally friendly recycling and disposal of this device and related

accessories, contact a facility certified to dispose of waste electrical and electronic

equipment. Recycling and disposal must be done in accordance with local

regulations.

1.5

Before connecting the device, be aware of the recommendations and considerations

outlined in this section.

1.5.1

All copper Ethernet ports on RUGGEDCOM products include transient suppression

circuitry to protect against damage from electrical transients and conform with

RUGGEDCOM M2100F

Installation Manual, 04/2022, C79000-G8976-1342-09

about connecting to the device via the serial console port, refer to

"Connecting to the Device (Page

Tools/Materials

1.3 Required Tools and Materials

19)".

Purpose

For connecting power to the device.

For connecting the device to the network.

For mounting the device to a DIN rail.

For mounting the device to a panel.

Introduction