EPSON PowerLite 7800p Projector
Adjusting the Image Shape
In most cases, you can maintain a rectangular image by
placing the projector directly in front of the center of the
screen with the base of the lens level with the bottom of the
screen.
Even if the projector is slightly tilted (within a range of 40° up
or down), the projector's automatic keystone correction
function detects and corrects vertical keystone distortion.
Projector tilted up
Corrected image
It takes about one second after projection starts for the image
to be corrected. During this time, a vertical keystone
correction gauge appears on the screen.
If your image is still distorted, you can correct it using either
of these methods:
If the image has two parallel
sides but is wider on the top,
bottom, left, or right, you
can correct it using the
keys on the
Keystone
projector's control panel or
the Keystone menu (see
"Using Keystone
Correction" below).
If the image is trapezoid-
shaped (no two sides are
parallel), you can adjust its
shape using Quick Corner
as described below.
You cannot use both keystone correction and Quick Corner at
the same time.
8
EPSON PowerLite 7800p Projector
-
Projector tilted down
Keystone correction
Keystone correction
™
Quick Corner correction
Using Keystone Correction
To adjust your image when it is wider on one side, do one of
the following:
Look at the shapes of the icons on the
projector's four
Keystone
Press the button whose icon is the
opposite shape of your screen image.
Continue pressing the button until
you are satisfied with the shape of the
image.
Note: The image will be slightly shorter after adjusting. If it's
important to maintain the correct aspect ratio, use the menu
system to perform keystone correction, as described below,
then adjust the Height setting as needed.
Press the
button on the remote control, select the
Menu
Setting menu, and press
select
H/V-Keystone
. Select
Enter
V-Keystone
or
(for horizontal keystone distortion) and
H-Keystone
press
. Use the
Enter
control to adjust the keystone setting as needed.
Using Quick Corner
Use Quick Corner to correct the image shape when it's
uneven on the top and bottom, or on all sides.
1. Press the
button on the remote control (or on the
Menu
projector's control panel).
2. Select the
Setting
3. From the Setting menu, select
4. Select
Quick Corner
You see this screen:
5. Press the
button to
Enter
select the corner you want to
adjust.
6. Use the
pointer button on
the remote control (or the
arrow buttons on the
projector) to adjust the shape.
7. Repeat steps 5 and 6 as needed
to adjust any remaining corners.
8. When done, press the
exit the menu system.
If
remains selected in the Keystone menu, the
Quick Corner
Quick Corner screen appears whenever you press the
projector's
Keystone
through 8 above to correct the shape of your image, or press
to exit Quick Corner.
ESC
5/03
buttons.
. From the Setting menu,
Enter
in the Keystone menu and press
(for vertical keystone distortion)
pointer button on the remote
menu and press
.
Enter
and press
Keystone
and press
.
Enter
[
]:Adjust
Adjust
/
[
[
]
]
:Move next
:Move next
[ESC]
[ESC] :Return (Press 1 second to
:Return (Press 1 second to
reset)
reset)
button on the remote control to
ESC
buttons. You can then follow steps 5
.
Enter
Seite drucken