Siemens TL-30U Einbauanleitung - Seite 2

Blättern Sie online oder laden Sie pdf Einbauanleitung für Kontrolleinheit Siemens TL-30U herunter. Siemens TL-30U 2 Seiten. Time limit module

Typical Wiring

Programming the TL-30U

There are two jumpers and one potentiometer on the

component board used to program the module.

TIME IN/TIME OUT JUMPER*

COM.

Determines whether TL-30U will be

time in or time out. Connect jumper

between common and T0 or TI.

*Time in denotes delay time period before

terminal 3 goes high (+).

Adjust potentiometer R13 (500K) for the exact time

period desired. Cross-zoning may be accomplished

without the use of zone operated relays. The two zone

outputs are fed directly into the TL-30U (terminals 1

and 2). After the second zone has activated, the TL-30U

will time as programmed.

NOTES

1. Jumper terminal 2 to terminal 1.

2. All input/output signals not supervised.

3. Minimum wire size: 18 AWG

Maximum wire size: 12 AWG

4. Terminals 1-6 are power limited.

P/N 315-021315-10

LONG TIME/SHORT TIME JUMPER

COM.

Determines timing period. LT: 30 sec

-10 min, ST: 1-20 sec. Connect

jumper between common and LT or ST.