Cisco 7861 Handbuch - Seite 11

Blättern Sie online oder laden Sie pdf Handbuch für IP-Telefon Cisco 7861 herunter. Cisco 7861 27 Seiten. Mpp phones
Auch für Cisco 7861: Anmerkungen zur Veröffentlichung (16 seiten), Schnellstart-Handbuch (2 seiten), Kurzreferenz-Handbuch (4 seiten), Kurzreferenz (4 seiten), Referenzhandbuch (11 seiten), Firmware Migration Master Manual (31 seiten), Installationshandbuch (39 seiten), Handbuch (20 seiten), Handbuch zur Rekonfiguration (2 seiten), Schnellstart-Handbuch (2 seiten)

Wall Mounts

Install the Non-Lockable Wall Mount Kit

The wall mount kit can be mounted on most surfaces, including concrete, brick, and similar hard surfaces.

To mount the kit on concrete, brick, or similar hard surfaces, you must provide the appropriate screws and

anchors for your wall surface.

Before you begin

You need these tools to install the bracket:

• #1 and #2 Phillips-head screwdrivers

• Level

• Pencil

You must also install an Ethernet jack for the phone in the desired location if an Ethernet jack does not currently

exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a regular phone jack.

Procedure

Step 1

Mount the wall bracket in the desired location. You can install the bracket over an Ethernet jack, or you can

run the Ethernet network cable to a nearby jack.

Note

a) Hold the bracket on the wall and place it so that the arrow on the back of the bracket points up.

b) Use the level to ensure that the bracket is level and use a pencil to mark the screw holes.

c) Using a #2 Phillips-head screwdriver, carefully center the anchor over the pencil mark and press the anchor

into the wall.

d) Screw the anchor clockwise into the wall until it is seated flush.

e) Use the included screws and a #2 Phillips-head screwdriver to attach the bracket to the wall.

If the jack is to be placed behind the phone, the Ethernet jack must be flush to the wall or recessed.

Install the Non-Lockable Wall Mount Kit

Wall Mounts