Siemens Silver WD 1000 TOP WD 1200 Betriebs- und Installationsanleitung - Seite 24
Blättern Sie online oder laden Sie pdf Betriebs- und Installationsanleitung für Waschmaschine Siemens Silver WD 1000 TOP WD 1200 herunter. Siemens Silver WD 1000 TOP WD 1200 28 Seiten.
en
Water Supply Intallation
If you use Chinese type water inlet pipe,
water connection see fig. 19 , 21 , 22
Please observe the following install steps
carefully.
1. Pull down the block ring 2 (Fig. 22 ). Sepa-
rating the water pipe form the main joint.
2. Unscrew the sealing ring3.
3. Loose the four screws 4.
4. Press the main joint against the tap with
force, then fix the screws simultaneously.
5. Screw the sealing ring 3 upward to make
the connection tight and water proof.
6. Fix the end of the pipe 6 on the connection
pipe of the electrovalve.
7. Push down the block ring 2, fix the pipe
onto the water tap.
8. Open the tap at the Max. Position, checking
if there is any water leakage. If any water
leakage, then you should assemble it again.
9. The main joint can be apart from the pipe
easily. It is not necessary to disassemble
the main joint from the water tape.
The edge fo the water tape must be even.
22
Drainage
! When installing the machine, do not bend the
drain hose or pull on it.
! When draining into a sink the drain hose
must not slip out of the sink and fall
onto the floor. To prevent flooding, ensure
that the water is draining fast enough out
of the sink and that the plug is not restricting
the outflow.
Installation see Fig. 20
Electrical Connection
Caution
! The washing machine must only be
connected to alternating current and
using a properly installed socket outlet
with earthing contact.
! The mains voltage must correspond to the
voltage specification on the washing
machine (nameplate). Connection
specifications as well as the required fuses
are stipulated on the appliance nameplate.
! Make sure that:
- the mains plug fits the socket outlet.
- the cable cross-section is permissible.
- the earthing system is properly installed.
! The mains cable may be replaced by an
electrician only.
Replacement mains cable available from
customer service.
! Do not use multiple plugs / connectors or
extension cables.
! In the event that an earth-leakage circuit
breaker is to be used, only use types
marked with following symbol:
this symbol can guarantee compliance with
all current regulations.
! Do not insert / remove the mains plug with
wet or damp hands.
! Handle the plug body only when removing
the plug from the socket.
. Only