Siemens WM T Series Gebrauchsanweisung und Installationsanleitung - Seite 29
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung und Installationsanleitung für Waschmaschine Siemens WM T Series herunter. Siemens WM T Series 46 Seiten.
Seite drucken
For programmes in which automatic
dosing is not possible or not desired (in
which case, intelligent dosing is
deactivated), you can add suitable
detergent to the compartment in the
detergent drawer for manual dosing.
~ "Manual dosing" on page 34
Start the programme
Touch Ü on the control panel.
The programme starts and the
Ü symbol lights up.
The door is locked and the
corresponding ® symbol lights up.
The drum rotates and load detection
takes place (takes up to two minutes).
The current programme information is
displayed during the programme:
Finish in-time or, after the washing
■
programme has started, the
programme duration
And the programme progress
■
indicators light up.
~ Page 20
Information on the following programme
steps and settings, which can be
changed while the programme is in
progress, lights up at half brightness.
Note:
Foam detection
If the o symbol also lights up, the
washing machine has detected too
much foam during the washing
programme and automatically activated
additional rinse cycles to remove the
foam.
Add less detergent the next time you
run a wash cycle with the same load.
If you want to lock the programme to
prevent the settings from being
changed inadvertently, you can select
the childproof lock as follows.
Operating the appliance
Childlock/operation lock
w 3 sec
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently in the
control panel.
To activate/deactivate the childproof
lock, touch and hold the control panel
w 3 sec for approx. three seconds.
The display switches to full brightness.
If you turn the programme selector or
touch the control panel while the
childproof lock is active, the w 3 sec
indicator flashes briefly and a signal
sounds. The programme runs through
to the end unchanged.
Notes
The childproof lock can be activated
■
regardless of the appliance's status.
The childproof lock remains active,
■
even once the washing machine has
been switched off.
If the appliance is switched off while
■
the programme is running and the
childproof lock has been activated,
the programme will resume when the
appliance is switched back on.
Adding laundry
After starting the programme, you can
add or remove laundry if necessary.
To do this, touch the control panel Ü.
The indicator flashes. The machine is
paused and checks whether a top-up is
possible.
If the display ® goes out, a top-up is
possible. The door is then unlocked and
can be opened.
To continue the programme. touch Ü
again. The programme continues
automatically.
en
29