Siemens WM**U series Handbuch für Installation und Betrieb - Seite 18
Blättern Sie online oder laden Sie pdf Handbuch für Installation und Betrieb für Waschmaschine Siemens WM**U series herunter. Siemens WM**U series 40 Seiten.
Seite drucken
Operating the appliance
en
Childlock
(w 3 sec)
You can lock the appliance to prevent
the functions you have set from being
changed inadvertently in the control
panel.
To activate the childlock:
After the programme starts, touch and
hold the w 3 sec button for approx.
three seconds. The display switches to
full brightness.
If you touch the control panel while the
childlock is actived, the w 3 sec
indicator will flash briefly and a signal
will sound. The programme runs
through to the end unchanged.
When the programme ends, End
Note:
is displayed. The door is closed. w 3
sec indicator still lights up and Œ
symbols remain on to remind you to
deactivate the childlock.
To deactivate the childlock:
Touch and hold the w 3 sec button
until the indicator turns off.
Notes
To remove the laundry at the end of
■
the programme,deactivate the
childlock.
The childlock remains active, even
■
once the appliance has been
switched off.
If the appliance is switched off while
■
the programme is running and
childlock is activated, the
programme continues when the
appliance is switched back on.
Adding/removing laundry
After starting the programme, you can
add or remove laundry if necessary.
Touch the I button. The appliance
checks whether reloading is possible.
18
If the following appears on the Touch-
Display:
The symbol Πdisappears, reloading
■
is possible.
The symbol Πlights up, reloading is
■
not possible.
To continue the programme, touch the
I button. The programme continues
automatically.
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
Touch the I button.
1.
Select another programme.
2.
And touch the I button again. The
3.
new programme starts from the
beginning.
Cancel the programme
For programmes at high temperatures:
Touch the I button.
1.
To cool down laundry: Select
2.
q Rinse/Spin 0
And touch the I button again.
3.
For programmes at low temperatures:
Touch the I button.
1.
Select q Rinse/Spin 0
2.
And touch the I button again.
3.