Siemens WM08X160IN Betriebsanleitung - Seite 8

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Waschmaschine Siemens WM08X160IN herunter. Siemens WM08X160IN 10 Seiten.

Seite drucken
Cleaning and care
Detergent solution pump
– Set the programme selector to Off , pull out the mains plug.
1. Open and remove the maintenance cover.
2. Carefully unscrew the pump cover - do not remove it completely.
3. Let the water drain into a shallow container (let the remainder drip
onto a floor cloth). Repeat the operation until there is no water left.
4. Remove the pump cover. Remove foreign material/fluff from inside the
pump.
5. Clean the interior, pump cover thread and pump housing
(fan impeller in the detergent solution pump must be able to rotate).
6. Refit the pump cover and screw on tightly.
7. Insert the maintenance cover and close it.
To prevent unused detergent from flowing into the outlet during the next
wash: pour 1 litre of water into dispenser II and start the Spin
programme.
Filter in the water inlet hose
Reduce the water pressure in the supply hose:
1. Turn off the tap.
2. Select any programme (except Spin
3. Press Start/Reload
. Leave programme running for approx. 40 seconds.
4. Set the programme selector to Off . Pull out the mains plug.
Clean the filter:
1. Remove the hose from the tap.
Clean the filter with a small brush.
1.
or
Remove the hose from the rear of the appliance.
Remove filter with pliers and clean.
2. Reconnect the hose and check for leaks.
– Risk of scalding. Allow detergent
solution to cool down.
– Turn off the tap.
1
and Empty
).

Consumption values

Programme
1
Cottons
40
Cottons
60
2
Cottons
Eco
60
Synthetics
Delicate/Silk
Wool
Programme setting for testing and energy labelling in accordance with GB standard.
*
**
The values deviate from the indicated values depending on water pressure, hardness, and inlet
temperature, ambiente temperature, type, amount and soiling of the laundry, detergent used,
fluctuations in the power supply and selected additional functions.
2
Fault displays
E:17
– Tap turned on?
– Water inlet hose kinked or jammed?
– Filter blocked? Clean filter
– Water pressure too low?
E:18
– Loose debris is blocking the pump, clean the pump
– Drainage hose blocked?
Other displays
Switch off the appliance, wait 5 seconds and switch it back on.
If the display appears again, call customer service.
10
Additional
Electricity
Load
function
consumption**
-
5,2 kg
0,46 kWh
-
5,2 kg
1,02 kWh
*
-
5,2 kg
0,98 kWh
-
2,6 kg
0,30 kWh
-
2,0 kg
0,20 kWh
-
2,0 kg
0,20 kWh
Page 10
Programme
Water**
duration**
52 l
1:19 h
52 l
1:24 h
55 l
3:56 h
40 l
1:09 h
44 l
0:43 h
35 l
0:43 h
Page 10
11