Siemens WM12S441ME Gebrauchsanweisung - Seite 2

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Waschmaschine Siemens WM12S441ME herunter. Siemens WM12S441ME 8 Seiten. Wm12s441me

Seite drucken
Safety instructions
Care
- Read the instruction manual and installation instructions and all other information enclosed
with the washing machine and act accordingly.
- Retain the documents for subsequent use.
Risk of electric shock
- Never pull the cable to disconnect the mains plug.
- Never insert/disconnect the mains plug with damp hands.
Danger to life
For worn out appliances:
- Disconnect the mains plug.
- Sever the mains cable and discard along with the plug.
- Destroy the lock on the washing machine door.
1.
This will prevent children from locking themselves in and risking
their lives.
Danger of suffocation
- Keep packaging, film and packaging parts out of the reach of
2.
children.
Risk of poisoning
- Keep detergents and care products out of the reach of children.
3.
Risk of explosion
- Items of laundry pretreated with cleaning agents containing
solvents, e.g. stain remover / cleaning solvent may lead to an
4.
explosion after being loaded into the washing machine. Rinse
items of laundry thoroughly by hand beforehand.
Risk of injury
- The washing machine door can become very hot.
- Be careful when draining hot detergent solution.
- Do not climb onto the washing machine.
- Do not lean on the open washing machine door.
- Do not reach into the drum if it is still rotating.
Consumption values
Programme
Additonal
Load
Power
Water**
Programme
function
rating**
duration**
30 °C*
v
Cottons
Intensive
8,0 kg
0.61 kWh
80 l
2:12 h
40 °C*
v
Cottons
Intensive
8,0 kg
0.94 kWh
80 l
2:12 h
60 °C*
v
Cottons
Intensive
8,0 kg
1.65 kWh
80 l
2:12 h
Cottons Eco 60 °C*
v
Intensive
8,0 kg
1.36 kWh
56 l
2:15 h
90 °C
v
Cottons
Intensive
8,0 kg
2.73 kWh
97 l
2:12 h
Easy Care A 40 °C*
v
Intensive
3,5 kg
0.55 kWh
53 l
1:12 h
Easy Care A 40 °C*
Information on the display panel
(also suitable as Short
-
3,5 kg
0.54 kWh
53 l
0:45 h
programme)
Delicate/Silk q Å (cold)
-
2,0 kg
0.03 kWh
39 l
0:40 h
F: 16
Delicate/Silk q 30 °C
-
2,0 kg
0.20 kWh
39 l
0:40 h
F: 17, 29
u
Wool U Å (cold)
-
2,0 kg
0.08 kWh
47 l
0:36 h
u
Wool U 30 °C
-
2,0 kg
0.20 kWh
47 l
0:36 h
F: 18
* Programme setting to be tested in accordance with European standard 60 456.
F: 23
Note on comparative tests: test the test programme with maximum load, Intensive v additional
function selected, maximum spin speed.
F: 42, 43, 44
A short programme which can be used for coloured items is Easy Care A 40 ºC,
Other displays
with the Intensive v additional function selected and set to maximum spin speed.
** The values deviate from the indicated values depending on water pressure, water hardness, water
inlet temperature, room temperature, type and amount of washing and degree of soiling,
7
8
utilised detergent, fluctuations in the mains voltage and selected additional functions.
Risk of electric shock
Maintenance
Disconnect the mains plug.
Risk of explosion. No solvents.
Machine housing, control panel
Detergent solution pump
- Wipe with a soft, damp cloth.
Set the programme selector to OFF, disconnect the mains plug.
- Do not use any abrasive cloths, sponges or cleaning agents (stainless steel cleaner).
- Remove detergent and cleaning agent residue immediately.
1.
Open and remove the service flap.
- Do not clean with a jet of water.
Cleaning the detergent drawer ...
2.
Take the drainage hose out of the retainer.
... if it contains detergent or fabric softener residues.
Remove the sealing cap, allow the detergent solution to flow out.
Pull out, press insert down, remove completely.
Push the sealing cap back on.
To remove the insert: press the insert upwards from below with your finger.
Clean the detergent dispenser tray and insert with water and a brush
and dry it.
3.
Carefully unscrew the pump cover (residual water).
Attach the insert and engage (connect the cylinder to the guide pin).
4.
Clean the interior, pump cover thread and pump housing (the impeller in the
detergent solution pump must rotate).
Push in the detergent drawer.
Leave the detergent drawer open so that any residual water can evaporate.
5.
Reinsert the pump cover and screw on tightly. The handle should be upright.
Place the drainage hose back in the retainer.
Drum
6.
Place the service flap back on and close.
Leave the washing machine door open so that the drum can dry out.
Rust stains use chlorine free cleaning agent, not steel wool.
Descaling
Make sure there is no laundry in the machine
To prevent unused detergent from flowing straight into the drain during the next wash:
Pour 1 litre of water into compartment II and start the b Empty programme.
Not necessary if the detergent is measured out correctly. However, if it is, follow the instructions
of the descaling agent manufacturer.
Insert for liquid detergent
depending on the model
Filter in the water supply
Position the insert for dispensing liquid detergent:
Risk of electric shock
- Take the detergent drawer out completely -> page 9.
- Slide the insert forwards.
Reduce the water pressure in the supply hose:
Do not use the insert (slide upwards):
1.
Turn off the tap.
- for gel detergents and washing powder,
2.
Select any programme (except Spin B/b Empty).
- for programmes with Prewash and W (Finish in) option.
Select Start/Pause M. Let the programme run for approximately 40
3.
seconds.
4.
Set the programme selector to OFF. Disconnect the mains plug.
depending on model
Clean the filter:
1.
Depending on model:
Close the washing machine door properly; laundry may be caught.
- Disconnect the hose from the tap.
Turn the tap on fully; supply hose kinked/trapped;
Clean the filter with a small brush.
Clean the filter -> page 10; water pressure too low.
Clean the detergent solution pump -> page 10; waste pipe/drainage hose
or
blocked.
Water in the base tub, appliance leaking. Call customer services.
- Remove the hose on the rear,
Motor fault. Call customer services.
Remove the filter with pliers and clean.
2.
Connect the hose and check for leaks.
Switch off the appliance, wait for 5 seconds and switch it back on.
If the display appears again, call customer services ->
Installation instructions, page 7.
9
Risk of scalding.
What to do if ...
Allow the detergent solution to cool down.
Turn off the tap.
F
Water is leaking out.
- Attach/replace the drainage hose correctly.
- Tighten the screw connection of the supply hose.
- Start/Pause M not selected?
F
No water supply.
Detergent not dispensed.
- Tap not turned on?
- Filter blocked? Clean the filter -> page 10.
- Supply hose kinked or trapped?
F
Washing machine door
- Safety function active. Programme stopped? -> page 4.
cannot be opened.
- D (Rinse stop = without final spin) selected? -> page 4.
- Can be opened by emergency release only? -> page 6.
F
Programme does not start.
- Start/Pause M or
- Washing machine door closed?
F
Detergent solution is not
- Clean the detergent solution pump -> page 10.
drained.
- Clean the waste pipe and/or drainage hose.
F
Water not visible in the drum. - Not a fault water below the visible area.
F
Spin result not satisfactory.
- Wash small and large items of laundry together.
- Anticrease f selected? -> page 5.
- Too low a speed selected? -> page 3.
F
Spin cycle performed several
- Not a fault unbalanced load detection system adjusts the
times.
imbalance.
F
Compartment
2
not rinsed
- Remove the insert. Clean the detergent drawer and insert
-> page 9.
out completely.
F
Odour formation in the
- Run the
Cottons 90 ºC programme without laundry. Use
washing machine.
standard detergent.
F
Foam escapes from the
- Too much detergent used?
detergent drawer.
Mix 1 tablespoon of fabric softener with ½ litre of water and
pour into compartment II of the detergent drawer.
Do not immerse the HydroSafe safety device in water
- Reduce the detergent dosage for the next wash cycle.
(contains an electric valve).
F
Intense noise formation,
- Are the appliance feet fixed?
vibrations and wandering"
Secure the appliance feet -> Installation instructions, page 5.
- Transportation safety device removed?
during the spin cycle.
Remove the transportation safety devices -> Installation
instructions, page 3.
F
Display panel/indicator lamps
- Power failure?
do not function during
- Fuse tripped? Reset/change the fuse.
operation.
- If the fault occurs repeatedly, call customer services.
F
Programme sequence longer
- Not a fault unbalanced load detection system adjusts
than usual.
imbalance by repeatedly distributing the laundry.
- Not a fault foam detection system active -> page 5.
F
Detergent residues on the
- Occasionally, phosphate free detergents contain
laundry.
water insoluble residues.
- Select Rinse K or brush the laundry after washing.
F
In pause mode,
- Water level too high. Not possible to add laundry. Close the
Start/Pause M flashes very
washing machine door immediately if necessary.
quickly and a signal sounds.
- Select Start/Pause to continue the programme.
F
If you cannot correct a fault yourself or a repair is required:
- Set the programme selector to OFF and pull the mains plug out of the socket.
- Turn off the tap and call customer services -> Installation instructions, page 7.
10
Operating instructions
Á
(Ready in) selected?
Washing
machine
Read these instructions before switching on the washing machine!Also
follow the separate Installation instructions.
Follow the safety instructions on page 8!
11
11
en