Siemens WM12W460IL Gebrauchsanweisung und Installationsanleitung - Seite 30
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung und Installationsanleitung für Waschmaschine Siemens WM12W460IL herunter. Siemens WM12W460IL 44 Seiten.
Seite druckenFaults and what to do about them.
en
Faults
The drum briefly jerks or
judders after the
programme has started.
The water is not draining.
Water is not visible in the
drum.
The spin result is not
satisfactory.
Laundry is wet/too damp.
The spin cycle runs
several times.
The programme is taking
longer than usual.
The length of the
programme changes
during the wash cycle.
Residual water in the
care-product
compartment i .
Odours in the washing
machine.
The o symbol lights up in
the display panel. Foam
may also be leaking from
the detergent drawer.
Loud noises, vibrations
and machine "movement"
during the spin cycle.
30
Cause/Remedy
Not a fault – the internal motor test may cause the drum to jerk or judder briefly
when the wash programme starts.
Is $ selected (Rinse Stop = no final spin)? ~ Page 23
■
Clean the drain pump. ~ Page 26
■
Clean the drain pipe and/or the drain hose.
■
Not a fault – the water is below the visible area.
Not a fault – the unbalanced load detection system has interrupted the spin
■
cycle because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum.
Is Less ironing æ selected (depending on the model)? ~ Page 19
■
Is the selected speed too low?
■
Not a fault – the unbalanced load detection system is adjusting an imbalance.
Not a fault – the unbalanced load detection system is adjusting an
■
imbalance by repeatedly distributing the laundry.
Not a fault – the foam detection system is active – a rinse cycle has been
■
switched on. ~ Page 22
Not a fault – the programme sequence is optimised for the specific washing
process. This may change the length of the programme shown in the display
panel.
Not a fault – the effect of the care product is not affected.
■
Clean the insert if necessary. ~ Page 26
■
Run the Cottons 90 °C programme without laundry.
Add washing powder or a detergent containing bleach.
Note: .
To prevent foaming, only use half of the amount of detergent
recommended by the detergent manufacturer. Do not use detergents designed
for woollens or delicates.
Have you used too much detergent?
Mix one tablespoon of fabric softener with 1/2 litre of water and pour it into
compartment II (not suitable for outdoor clothing, sportswear or items stuffed
with down).
Use less detergent in the next washing cycle.
Is the appliance aligned? Align the appliance. ~ Page 38
■
Are the appliance's feet fixed? Secure the appliance's feet. ~ Page 38
■
Have the transport braces been removed? Remove the transport braces.
■
~ Page 35