Siemens Type Vector Gebrauchsanweisung - Seite 4

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Schalter Siemens Type Vector herunter. Siemens Type Vector 18 Seiten. Manual group-operated switch

Seite drucken

Introduction

The type Vector® manual group-operated

switch is designed to meet all applicable

ANSI, NEMA and IEEE standards.

Successful application and operation of

this equipment depends as much upon

proper installation and maintenance by the

user as it does upon the proper design and

fabrication by Siemens.

The purpose of this instruction manual is

to assist the user in developing safe and

efficient procedures for the installation,

maintenance and use of the equipment.

Contact the nearest Siemens

representative if any additional

information is desired.

Arc flash hazard and hazardous voltages.

Will cause death, serious injury or property damage.

Always de-energize and ground the equipment before

maintenance. Read and understand this instruction manual

before using equipment. Maintenance should be performed only

by qualified personnel. The use of unauthorized parts in the

repair of the equipment or tampering by unqualified personnel

will result in dangerous conditions which will cause death, severe

injury or equipment damage. Follow all safety instructions

contained herein.

Arc flash hazard, hazardous voltages and high-speed moving

parts.

Will cause death, serious injury or property damage.

To avoid arc flash burns, electrical shock and entanglement in

moving parts, only qualified personnel should work on or around

this equipment after becoming thoroughly familiar with all

danger or warning notices, and procedures contained herein.

Personnel must observe all applicable regulations (e.g., OSHA),

follow all requirements of NFPA 70E and adhere to specific

operating procedures applicable to the installation. Use

appropriate personal protective equipment (PPE) for the voltage

and arc flash incident energy exposure.