Siemens dishwasher Betriebsanleitung - Seite 14

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Geschirrspüler Siemens dishwasher herunter. Siemens dishwasher 24 Seiten. Dishwasher
Auch für Siemens dishwasher: Gebrauchsanweisung Handbuch (29 seiten), Betriebsanleitung (30 seiten), Betriebsanleitung (30 seiten), Betriebsanleitung (30 seiten), Betriebsanleitung (28 seiten), Betriebsanleitung (26 seiten), Gebrauchsanweisung Handbuch (28 seiten), Gebrauchsanweisung Handbuch (26 seiten), Gebrauchsanweisung Handbuch (28 seiten), Gebrauchsanweisung Handbuch (32 seiten), Gebrauchsanweisung Handbuch (28 seiten), Gebrauchsanweisung Handbuch (34 seiten), Gebrauchsanweisung Handbuch (34 seiten), Gebrauchsanweisung Handbuch (28 seiten), Gebrauchsanweisung Handbuch (34 seiten), Gebrauchsanweisung Handbuch (26 seiten), Betriebsanleitung (40 seiten), Gebrauchsanweisung Handbuch (31 seiten), Gebrauchsanweisung Handbuch (40 seiten), Betriebsanleitung (28 seiten), Betriebsanleitung (28 seiten)

Seite drucken
Siemens dishwasher Betriebsanleitung
aus
S witching off automatically after
Sw i t c h i n g of f au t o m a t i c a l l y a f t e r t h e e n d of t h e pr o g r a m me
the end of the programme *
* depending on model
To save energy, the dishwasher is
switched off 1 minute after the programme
ends (factory setting).
Automatic disconnection can be adjusted
from
:
to :
:
Appliance does not switch off
automatically
:
Off after 1 min
:
Off after 120 min
– Close the door.
– Switch on ON/OFF switch (.
– Hold down programme button # and
press START button ` until : ... is
indicated on the digital display.
– Release both buttons.
– Press programme button # until the
factory set value
the digital display )".
To change the setting:
– Press programme button 3.
Each time the button is pressed, the
set value increases by one level; when
the value of :
the display jumps back to :
– Press START button `.
The set value is saved.

Switching off the appliance

Short time after the end of the programme:
– Switch off ON/OFF switch (.
– Turn off the tap (not applicable if Aqua-
Stop fitted).
– Open the door.
– Remove the utensils when they have
cooled down.
ã=
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.
14
.
:
is indicated on
has been reached,
(off).

Interrupting the programme

– Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave the
door ajar for several minutes and then
close. Otherwise, expansion (pressure)
may cause the appliance door to
spring open or water to run out of the
appliance.
– To continue the programme, switch on
the ON/OFF switch ( again.
T erminating the programme
Te r m i n a t i n g t h e pr o g r a m m e
(Reset)
– Press START button ` for
approx. 3 sec.
The numerical display )"
indicates :
– The programme sequence lasts
approx. 1 min. On the digital
display )" is indicated :
– Switch off ON/OFF switch (.

Changing the programme

When the START button ` has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme (Reset).

Intensive drying

The final rinse uses a higher temperature
which improves the drying result. The
running time may increase slightly.
(Caution if utensils are delicate!)
– Close the door.
– Switch on ON/OFF switch (.
– Hold down programme button # and
press START button ` until the
digital display )" : ... is indicated.
– Release both buttons.
To change the setting:
– Press the button 3 to switch the
Intensive drying on
– Press START button `.
The set value is saved.
.
.
:
or off :
.