Siemens SN 56N591 Betriebsanleitung - Seite 16
Blättern Sie online oder laden Sie pdf Betriebsanleitung für Geschirrspüler Siemens SN 56N591 herunter. Siemens SN 56N591 28 Seiten.
en
Remaining running time display
When the programme is selected, the
remaining running time of the programme
is indicated on the digital display )*.
The running time is determined during the
programme by the water temperature, the
number of utensils as well as the degree
of soiling and may vary (depending on the
selected programme).
Timer programming *
* depending on model
You can delay the start of the programme
in 1-hour steps up to 24 hours.
– Close the door.
– Switch on ON/OFF switch (.
– Press button X + until the digital
display )* jumps to :
– Press X + or – button until the
displayed time corresponds with your
requirements.
– Press START button h, timer
programming is activated.
– To delete timer programming, press
the X + or – button until )* :
indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when the
value :
is indicated on the numerical
display )*.
Switching off the appliance
Short time after the end of the programme:
– Switch off ON/OFF switch (.
– Turn off the tap (not applicable if Aqua-
Stop fitted).
– Remove the utensils when they have
cooled down.
16
Downloaded from DishWasher-Manual.com Manuals
ã=
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.
Interrupting the programme
– Switch off ON/OFF switch (.
.
– To continue the programme, switch on
Terminating the programme
(Reset)
– Press START button h for
is
– The programme sequence lasts
– Switch off ON/OFF switch (.
Changing the programme
When the START button h has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme (Reset).
Warning
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave the
door ajar for several minutes and then
close. Otherwise, expansion (pressure)
may cause the appliance door to
spring open or water to run out of the
appliance.
the ON/OFF switch ( again.
approx. 3 sec.
The numerical display )*
indicates :
.
approx. 1 min. On the digital
display )* is indicated :
.