Siemens SN 65E001 Gebrauchsanweisung Handbuch - Seite 16
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung Handbuch für Geschirrspüler Siemens SN 65E001 herunter. Siemens SN 65E001 28 Seiten.
en
Timer programming *
* depending on model
You can delay the start of the programme
by 3, 6 or 9 hours.
Switch on ON/OFF switch
Keep pressing the Preselected starting
time button
until the appropriate
2
display 3 h, 6 h or 9 h is lit.
Press Start button
The preselected starting time
is activated.
To delete the preselected starting time,
keep pressing the Preselected starting
time button
until none of the
2
displays 3 h, 6 h or 9 h is lit.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when the End
display
is lit.
8
The end of the programme is also
indicated by an acoustic signal.
The buzzer volume can be set in 4 stages.
Accordingly 0, 1, 2 or 3 displays are lit.
(see water hardness table).
Factory setting: 2.
This function can be changed as follows:
Open the door.
Switch on ON/OFF switch
Hold down button >
Start button
until the End display
9
and salt refill indicator
8
Release buttons.
Keep pressing button >
salt refill indicator
refill indicator
10
Release buttons.
The refill indicator
the displays
10
(= setting 2). The set buzzer volume
can be heard.
16
.
1
.
9
.
1
and press
6
flash.
11
until the
6
and rinse aid
11
flash.
flashes and
11
and A are B lit
Change the setting as follows:
ress button <
5
setting has been selected.
Press Start button
The displays go out.
The selected setting is saved.
Close the door.
Switching off the appliance
Short time after the end of the programme:
Open the door.
Switch off ON/OFF switch
Turn off the tap (not applicable
if Aqua-Stop fitted).
Remove the utensils when they have
cooled down.
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.
Interrupting the programme
Open the door.
Switch off ON/OFF switch
The LEDs go out. The programme
is saved.
If the door was opened on an appliance
which has a warm water connection
or is heated, first leave the door ajar
for several minutes and then close.
Otherwise, expansion (pressure) may
cause the appliance door to spring
open or water to run out of the
appliance.
To continue the programme, switch
on the ON/OFF switch
Close the door.
until the required
.
9
.
1
.
1
again.
1