Siemens SX Series Betriebsanweisungen - Seite 30

Blättern Sie online oder laden Sie pdf Betriebsanweisungen für Geschirrspüler Siemens SX Series herunter. Siemens SX Series 38 Seiten. Dishwasher
Auch für Siemens SX Series: Betriebsanleitung (38 seiten), Betriebsanleitung (42 seiten), Betriebsanleitung (42 seiten), Betriebsanleitung (44 seiten), Betriebsanleitung (46 seiten), Betriebsanleitung (44 seiten), Betriebsanleitung (42 seiten), Gebrauchsanweisung (48 seiten), Betriebsanleitung (40 seiten), Betriebsanleitung (42 seiten), Betriebsanleitung (44 seiten), Betriebsanleitung (40 seiten)

Siemens SX Series Betriebsanweisungen
en
Fault, what to do?
Fault
Removable streaks on
glasses, glasses with
metallic appearance and
cutlery.
Initial or existing,
irreversible clouding
of glass.
Rust spots on the cutlery.
The appliance does not
start.
Programme starts
automatically.
30
Cause
Too much rinse aid.
No rinse aid added or setting too
low.
Detergent residue in the final
rinse programme section.
Detergent dispenser cover
blocked by utensils (cover does
not open fully).
Utensils precleaned too intensely;
sensors therefore decide on
weak programme sequence.
Stubborn soiling cannot be
completely removed.
Glasses not dishwasher-proof,
only suitable for dishwasher.
Cutlery not adequately rust-
resistant. Knife blades are
frequently more severely
affected.
Cutlery will also rust if rusting
parts are rinsed at the same time
(pan handles, damaged utensil
baskets, etc.).
Salt content in the rinsing water
too high, as salt dispenser lock
not fastened firmly or salt was
spilled while being refilled.
The mains fuse has tripped.
Power cord not inserted.
The appliance door has not been
shut properly.
You did not wait until programme
ended.
Remedial action
Set rinse aid amount to lower setting.
Add rinse aid and check dosage
(recommended setting 4-5).
Detergent dispenser cover must not be
obstructed by utensils.
Do not place utensils or fragrance dispenser
in the tablet collecting tray.
Do not prerinse utensils. Remove only large
food remnants.
Recommended programme Eco 50°
Use dishwasher-proof glasses.
Avoid long steam phase (standing time after
wash cycle ends).
Use wash cycle at lower temperature.
Set water softening system according to the
water hardness (if required one setting
lower).
Use detergent with glass protection
component.
Use corrosion-resistant cutlery.
Do not wash rusting parts.
Fasten salt dispenser lock firmly or remove
spilled salt.
Check mains fuse.
Ensure that the power cord is plugged all
the way into the back of the appliance and
into the socket. Check that the socket
functions.
Close the door.
Perform reset.
(See Terminating the programme).