Siemens SX Series Betriebsanleitung - Seite 23

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Geschirrspüler Siemens SX Series herunter. Siemens SX Series 44 Seiten. Dishwasher
Auch für Siemens SX Series: Betriebsanweisungen (38 seiten), Betriebsanleitung (38 seiten), Betriebsanleitung (42 seiten), Betriebsanleitung (42 seiten), Betriebsanleitung (46 seiten), Betriebsanleitung (44 seiten), Betriebsanleitung (42 seiten), Gebrauchsanweisung (48 seiten), Betriebsanleitung (40 seiten), Betriebsanleitung (42 seiten), Betriebsanleitung (44 seiten), Betriebsanleitung (40 seiten)

Seite drucken
Siemens SX Series Betriebsanleitung

Switching on the appliance

1. Turn on the tap fully.
2. Open the door.
3. Switch on ON/OFF switch (.
The Eco 50° programme display
flashes. This programme remains
selected if no other programme
button 0 is pressed. The expected
programme duration
flashes on the digital display h.
4. Press the START button `.
5. Close the door.
The programme starts running.
Note
- for environmentally friendly operation
of the dishwasher:
For ecological reasons the Eco 50°
programme is preset whenever the
appliance starts. This conserves
environmental resources and not least
saves you money.
The Eco 50° programme is a
particularly environmentally friendly
programme. According to EU
regulation 1016/2010 it is the
"Standard programme" which is the
most efficient standard cleaning cycle
for cleaning normally soiled utensils in
terms of the combined energy and
water consumption for cleaning these
types of utensils.
Operating the appliance
Optical display while
the programme is running *
* depending on model
While the programme is running,
an optical display is indicated
on the floor under the appliance door.
If the base panel is pulled forwards
or if the appliance is installed at eye-
level with flush furniture front, the display
is not visible.
Possible settings of the optical
display:
:
The display is switched off.
:
Programme, timer programming,
remaining time, end of programme
and, if required, low water level are
displayed.
:
Same as :
information is also displayed,
e.g. the symbol for half load §
or glass protection system
active W.
:
is set at the factory.
To change the setting:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button `
until : .... is indicated on the digital
display.
4. Release both buttons.
The illuminated display of the
button # flashes.
5. Keep pressing programme
button # until the previously set
value, e.g. :
digital display h : ... (for the
optical display).
. Other programme
, is indicated on the
en
O p t i c a l d i s p l a y w h i l e t h e p r o g r a m m e i s r u n n i n g
23