Siemens SX Series Betriebsanleitung - Seite 23

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Geschirrspüler Siemens SX Series herunter. Siemens SX Series 42 Seiten. Dishwasher
Auch für Siemens SX Series: Betriebsanweisungen (38 seiten), Betriebsanleitung (38 seiten), Betriebsanleitung (42 seiten), Betriebsanleitung (42 seiten), Betriebsanleitung (44 seiten), Betriebsanleitung (46 seiten), Betriebsanleitung (44 seiten), Gebrauchsanweisung (48 seiten), Betriebsanleitung (40 seiten), Betriebsanleitung (42 seiten), Betriebsanleitung (44 seiten), Betriebsanleitung (40 seiten)

Seite drucken
Siemens SX Series Betriebsanleitung

End of programme

The programme has ended when the
value :
is indicated on the numerical
display )".
Switching off automatically
after the end of
the programme *
* depending on model
To save energy, the dishwasher is
switched off 1 minute after the
programme ends (factory setting).
Automatic disconnection
can be adjusted from :
:
Appliance does not switch off
automatically
:
Off after 1 min
:
Off after 120 min
1. Close the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button P
until : ... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes and
the digital display )" displays the
factory setting :
5. Press programme button # until
the factory set value :
is indicated on the digital
display )".
To change the setting:
1. Press programme button 3.
Each time the button is pressed, the
set value increases by one level;
when the value of :
reached, the display jumps back
to :
(off).
2. Press START button P.
The set value is saved.
S w i t c h i n g o f f a u t o m a t i c a l l y a f t e r t h e e n d o f t h e p r o g r a m m e
to :
.
.
has been
Operating the appliance

Switching off the appliance

Short time after the end of the
programme:
1. Switch off ON/OFF switch (.
2. Turn off the tap (not applicable if
Aqua-Stop fitted).
3. Remove the utensils when they have
cooled down.
Note
When the programme ends, leave
the appliance to cool down a while
before opening it. This will prevent
steam from escaping and causing long-
term damage to your built-in furniture.

Interrupting the programme

1. Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave
the door ajar for several minutes and
then close. Otherwise, expansion
(pressure) may cause the appliance
door to spring open or water to run
out of the appliance.
2. To continue the programme, switch
on the ON/OFF switch ( again.
en
23