Epson C11CA19201 - WorkForce 30 Color Inkjet Printer Kurzanleitung - Seite 31
Blättern Sie online oder laden Sie pdf Kurzanleitung für Projektor Epson C11CA19201 - WorkForce 30 Color Inkjet Printer herunter. Epson C11CA19201 - WorkForce 30 Color Inkjet Printer 36 Seiten. Color inkjet printer
Auch für Epson C11CA19201 - WorkForce 30 Color Inkjet Printer: Spezifikationsblatt (3 seiten), Schnellstart-Handbuch (9 seiten), Spezifikationen (2 seiten)
Seite drucken
■
After bringing an ink cartridge inside from a cold storage site, allow it to warm up at
room temperature for at least three hours before using it.
■
Store ink cartridges with their labels facing upward. Do not store cartridges upside
down.
FCC Compliance Statement
For United States Users
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio or
television reception. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause interference to radio and television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
■
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
■
Consult the dealer or an experienced radio/TV technician for help.
WARNING
The connection of a non-shielded equipment interface cable to this equipment will
invalidate the FCC Certification of this device and may cause interference levels which
exceed the limits established by the FCC for this equipment. It is the responsibility of the
user to obtain and use a shielded equipment interface cable with this device. If this
equipment has more than one interface connector, do not leave cables connected to
unused interfaces. Changes or modifications not expressly approved by the manufacturer
could void the user's authority to operate the equipment.
31
Notices