Epson ChromaBlast 1.0 Benutzerhandbuch - Seite 11

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Projektor Epson ChromaBlast 1.0 herunter. Epson ChromaBlast 1.0 13 Seiten. For epson stylus pro 4880
Auch für Epson ChromaBlast 1.0: Handbuch "Erste Schritte (47 seiten)

Seite drucken

Follow these steps to replace the lamp:

1. Press the P

button to turn the projector off, then

Power

wait for the P power light to stop flashing.

2. Unplug the power cord and disconnect any cables.

3. If the projector has been on, let it cool for at least one hour.

4. Turn the projector upside-down. Push in the tabs on the

lamp cover and push it up to remove it.

5. Use a small screwdriver to loosen the two screws securing the

lamp; you can't remove the screws.

6. Grasp the lamp as shown and pull it straight out.

EPSON PowerLite Home 10 Projector

7. Carefully insert the new lamp and tighten the retaining

screws.

8. To replace the lamp cover, insert the tabs and then snap the

cover into place.

Note: Make sure the lamp cover is securely fastened. The

warning light flashes and the projector lamp won't turn on if

the cover is open.

After replacing the lamp, you need to reset the lamp timer, as

described in the next section.

Resetting the Lamp Timer

After you install a new lamp, you need to reset the timer so the

projector can keep track of how many hours it has been used.

Note: Reset the lamp timer only after you install a new lamp. If you

reset it at any other time, the projector will not indicate the correct

number of lamp usage hours.

Follow these steps:

1. Make sure the power cord is connected to the projector and

to an electrical outlet.

2. Turn on the projector and wait for it to warm up.

3. Press the

button on the projector or remote control.

You see the main menu.

4. Select the

menu. You see the lamp usage hours and

Reset

other settings.

5. Select

Lamp Hours Reset

6. When you see a prompt asking whether you want to execute

the command, highlight

7. When you're finished, press

The lamp usage timer doesn't register until you've used the

lamp for at least 10 hours. After that, the timer updates lamp

usage in one hour increments.

7/03

EPSON PowerLite Home 10 Projector - 11

and press the

button.

Yes

Select

Esc