Cisco 8800 Series Handbuch - Seite 8

Charge Cisco Headset 561 and 562

Number

Name

Mute button

Volume button (

LED

Charge Cisco Headset 561 and 562

Use the headset base to charge the headset.

Procedure

Place the headset into the socket on the base.

The LEDs on the base station indicate the charging status. When the headset is fully charged, the five LEDs

on the base are steady white. If the LEDs don't light up, remove the headset from the base and try again.

Third Party Headsets

Cisco Systems performs internal testing of third-party headsets for use with Cisco IP Phones. But Cisco does

not certify or support products from headset or handset vendors.

Headsets connect to your phone using either the USB or the auxiliary port. Depending upon your headset

model, you have to adjust your phone's audio settings for the best audio experience, including the headset

sidetone setting.

If you have a third-party headset, and you apply a new sidetone setting, then wait one minute and reboot the

phone so the setting is stored in flash.

The phone reduces some background noise that a headset microphone detects. You can use a noise canceling

headset to further reduce the background noise and improve the overall audio quality.

If you are considering a third-party headset, we recommend the use of good quality external devices; for

example, headsets that are screened against unwanted radio frequency (RF) and audio frequency (AF) signals.

Cisco IP Phone Accessories

Description

Toggle the microphone on and off. When Mute on the headset is enabled:

• The Mute

only)

Adjust the volume on your headset.

and

)

Shows the headset status:

• Blinking red—Incoming call.

• Steady red—Active call.

• Flashing white every 6 seconds—The headset is paired and idle.

• Blinking white—Firmware upgrade is in process or the headset is

pairing with the base station.

button on the phone lights up.

button on the headset base lights up. (For Multibase

Cisco IP Phone Accessories