Cisco 8851 Benutzerhandbuch - Seite 3

PBXware Version

PBXware version

5.3.8

In order to find out the PBXware version:

Navigate to Settings: About.

On the top of About page is a code similar to this one Edition: Multi-Tenant, Release:

5.3.8.0

(2223ce45), Running: 13.23.1-gc-040bbaca, Proxy v5.3.8 (231c5f3), API: 5.3,

libmemcached version: 1.0.18, where Release denotes the current version of your PBXware.

This section describes how to install and connect the phone to the electrical power and data

network as well as how to apply factory settings.

The following topics are covered:

Factory Settings

Power Adapter

Connect the Network and Power

Connect the DC plug on the power adapter to the DC port on the phone and connect the other

end of the power adapter into an electrical power outlet.

Connect the Ethernet cable between the Internet port on the phone and the network port on a

router or switch to access LAN.

Find out your Cisco phone's IP Address

Press the Settings button

Type 72 to check the phone's IP address

IP address should be displayed on the phone.

This step is not required for brand new out-of-the-box phones, however, if the phone has been

already used, then it is a must.

Press the Settings button

Type 65

Confirm with OK to factory reset the phone