Digital Matter G62 Installationshandbuch - Seite 4
Blättern Sie online oder laden Sie pdf Installationshandbuch für GPS Digital Matter G62 herunter. Digital Matter G62 15 Seiten.
Auch für Digital Matter G62: Handbuch "Erste Schritte (3 seiten)
Seite drucken
G62
Installation Guide
Revision 1.0 -20 September 2018
Wiring Harness Description
Colour
Function
Red
External Power
Black
Ground
White
Ignition
Blue
Digital Input 1
Yellow
Digital Input 2
Brown
iButton
Green
Analogue Input/Switched
Ground Output
4. GETTING STARTED
The G62 may be damaged by electrostatic discharge if not handled correctly. Ensure
adequate static precautions are taken.
touching the antennae and any of the electronic components on the PCB. Take special care not
to touch the ceramic GPS antenna as static can damage the sensitive GPS circuitry.
Insert the SIM
1. The SIM holder is located on the top side of the main PCB.
2. Unplug the battery and remove any external power connections.
3. Slide the locking mechanism on the SIM holder to the "unlock" position, and lift the
hinged portion of the SIM holder.
4. Insert the micro SIM into the holder with the keyed corner orientated away from the
hinge and the SIM contacts orientated down to the PCB (see example above).
5. Close the SIM holder and slide the locking mechanism to the "lock" positon.
To easily get up and running:
1. The SIM should not have a PIN on it, unless you use the device specific PIN.
2. The SIM should have credit or airtime
3. The SIM should use one of the APN's built into the firmware. It is possible to set APN's
by SMS
G62 Installation Guide
Notes
8 – 36V DC external power
Main Ground
0 – 50V DC, permanent internal pull down
0 – 50V DC, configurable pull down
0 – 50V DC, configurable pull down
iButton input
Low side switch. Use with a relay, LED, or buzzer.
0 – 30V Analogue Input
Consider wearing an anti-static wrist guard. Avoid
All information provided in this document is subject to legal disclaimers
Revision 1.0 - 20 September 2018
© Digital Matter 2018
Page 4 of 15