Ricoh AC017 Schnellstart-Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Alles in einem Drucker Ricoh AC017 herunter. Ricoh AC017 15 Seiten. Ricoh ac104: quick start

Seite drucken

CAUTION:

• Protect the machine from dampness or wet weather, such as rain and snow.

• Unplug the power cord from the wall outlet before you move the machine. While moving

the machine, you should take care that the power cord will not be damaged under the

machine.

• When you disconnect the power plug from the wall outlet, always pull the plug (not the

cable).

• Do not allow paper clips, staples, or other small metallic objects to fall inside the

machine.

• Keep toner (used or unused) and toner bottle out of the reach of children.

• Be careful not to cut yourself on any sharp edges when you reach inside the product to

remove misfed sheets of paper or masters.

• For environmental reasons, do not dispose of the machine or expended supply waste at

household waste collection points. Disposal can take place at an authorized dealer.

• The inside of the machine could be very hot. Do not touch the parts with a label

indicating the "hot surface". Otherwise, an injury might occur.

Power Supply

The socket-outlet shall be in stalled near the product and shall be easily accessible.

Ozone Safety (if applicable)

Some product (see specification in the Operating Instructions) generates ozone during

operation.

Normally, the ozone level is safe for operators. If ozone odor may appear, ventilate the room.

For Fax or Telephone

Do not use this product near water, for example, near a bathtub, wash bowl, kitchen sink or

laundry tub, in a wet basement or near a swimming pool. Avoid using a telephone during an

electrical storm. There may be a remote risk of electric shock from lightning. Do not use a

telephone in the vicinity of a gas leak to report the leak.

Laser Safety:

This product (see specification in the Operating Instructions) is considered a class 1 laser device.

Safety precautions and interlock mechanisms have been designed to prevent any possible laser beam

exposure to the operator. The following label is attached to the back of European and Asian

specification machines only.

For North America

CDRH Regulations

This equipment complies with requirements of 21 CFR subchapter J for class 1 laser products.

This equipment contains a 5 milliwatt, 760–800 nanometer wavelength, AlGaAs laser diode.

This equipment does not emit hazardous radiation, since the beam is totally enclosed during

all customer modes of operation and maintenance.

Caution:

Use of controls or adjustment or performance of procedures other than those specified in this

manual might result in hazardous radiation exposure.

iii