Cisco 10005 ESR Handbuch - Seite 24

Blättern Sie online oder laden Sie pdf Handbuch für Netzwerk-Router Cisco 10005 ESR herunter. Cisco 10005 ESR 33 Seiten.

Removing and Replacing Field-Replaceable Units

Simultaneously pivot both ejector levers toward each other (until they are parallel

Step 9

to the faceplate) to firmly seat the card in the midplane.

The line card cycles through its power-on self-test. The Fail LED stays on briefly

(about 5 to 6 seconds) and then shuts off. If the Fail LED remains on or flashes,

refer to the Cisco 10000 Series Troubleshooting Guide.

Secure the line card in the chassis by tightening the left and right captive screws.

Step 10

To ensure that there is adequate space for additional line cards, always tighten the

Caution

captive screws on each newly installed line card before you insert any additional

line cards. These screws prevent accidental removal and provide proper grounding

for electromagnetic interference (EMI) shielding.

Reconnect any interface cables to the line card if necessary.

Step 11

Configure the line card if necessary. (See the Cisco 10000 Series ESR Software

Step 12

Configuration Guide for information about configuring the line card.)

Note

Cisco 10005 ESR Hardware Overview and Maintenance Guide

3-24

It is not necessary to configure the line card if this is a replacement

installation. The system automatically downloads the necessary

configuration information from the PRE.

Chapter 3

Maintaining the Cisco 10005 ESR

OL-1102-07