Cisco 1751 Schnellstart-Handbuch - Seite 12

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Netzwerk-Router Cisco 1751 herunter. Cisco 1751 35 Seiten. Modular access router
Auch für Cisco 1751: Überblick über die Lösung (16 seiten), Datenblatt (19 seiten)

Seite drucken

Configuring Voice-over-IP

Information for International Users

International users must set the values of certain voice-port commands, like cptone, that are specific to

their country. Refer to the Cisco 1751 Router Software Configuration Guide for details.

Entering Configuration Mode

You can configure your router for VoIP by entering commands at the CLI. This method of entering

commands is called configuration mode.

Note

VoIP requires one of the following IOS Release 11.3(1)T (or later) feature sets: IP Plus, Desktop Plus,

or Enterprise Plus.

Follow these steps to enter configuration mode:

Connect a terminal or PC to the router.

Step 1

To configure the router with a PC, the PC must have some type of terminal emulation software installed.

The software should be configured with the following parameters: 9600 baud, 8 data bits, no parity, 1

stop bit.

Step 2

Power up the router.

Step 3

If the current configuration is no longer valid (for instance, because you added an interface), after about

1 minute you will see the following prompt:

Would you like to enter the initial configuration dialog? [yes]:

Do not use the yes default. You need to enter no to enter the normal operating mode of the router.

If the current configuration is valid, you enter the normal operating mode automatically.

Note

Step 4

At the user EXEC prompt (

Router> enable

Password:

Configuration changes can be made only in enable mode. The prompt changes to the privileged EXEC

(enable) prompt (

Router#

Enter the following command to enter global configuration mode:

Step 5

Router# config terminal

Router(config)#

If you have not configured the router before or want to change the configuration, you need to configure

Step 6

global parameters, passwords, network management, and routing protocols. In this example, IP routing,

AppleTalk routing, and IPX routing are all enabled:

Router(config)# ip routing

Router(config)# appletalk routing

Router(config)# ipx routing

Cisco 1751 Voice-over-IP Quick Start Guide

), enter enable and the password to enter enable mode:

Router>

Router#

78-11259-05