Epson EMP-703 Kurzreferenz-Handbuch - Seite 15
Blättern Sie online oder laden Sie pdf Kurzreferenz-Handbuch für Projektor Epson EMP-703 herunter. Epson EMP-703 17 Seiten. Epson emp-703: specifications
Auch für Epson EMP-703: Spezifikationen (3 seiten)
Seite drucken
Page 39 of Owner's Manual
Checking the Indicators
The projector is equipped with indicators that alert you to problems with projector operation.
The following tables show what the indicators mean and how to remedy problems that they indicate.
Operation indicator
Lamp indicator
Temperature indicator
Operation Indicator
Indicator status
Problem and remedy
Standby condition
Illuminated
in Orange
Projection starts when the
Cool-down in progress
Blinking
After while, the projector switches to the
in Orange
standby condition (the indicator lights orange).
Illuminated
Projecting in progress
in Green
Warm-up in progress
Blinking
After warm-up is complete, projection
in Green
will start when a video signal is input.
Internal problem
Blinking
Stop using the projector and ask for projector
in Red
to be repaired.
*1
The power is not switched on
Extinguished
*1 If an indicator is showing a status which does not appear in the previous tables,
Warranty Conditions" in "Safety Instructions/World-Wide Warranty Terms" included in the package.
*2 Contact your dealer for a spare lamp.
Lamp Indicator
Indicator status
Blinking
in Red
Illuminated
in Red
Blinking
in Orange
Extinguished
Temperature Indicator
Indicator status
Illuminated
Power
is pressed.
in Red
Blinking
in Red
Blinking
in Orange
Extinguished
contact your dealer or nearest address provided at "International
Problem and remedy
Lamp error
Replace the lamp with a new one
.*2
Time to replace the lamp.
Replace the lamp with a new one
.*2
Nearing the time for replacing the lamp
Prepare a new
lamp.*2
The power has not been switched on or normal
projection is in progress.
Problem and remedy
Excessive internal temperature (overheating)
The lamp goes off automatically and projection
becomes impossible. Wait for approximately 5
minutes with the projector in that state. After 5
minutes has passed, pull out the power plug
once, then insert it again.
When the power plug is reinserted, the projector
will recover to the normal state, so press the
Power
and turn on the power again.
Internal problem
Stop using the projector and ask for projector
to be repaired.
*1
High-speed cooling in progress.
If the internal temperature rises any higher,
projection will stop.
Check that the air inlet and exhaust vents are clear
and that the indoor temperature is not too high.
The power has not been switched on or normal
projection is in progress.
Troubleshooting
14