Cisco 2600 Series Installationshandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Installationshandbuch für Netzwerk-Router Cisco 2600 Series herunter. Cisco 2600 Series 12 Seiten. Configuring adsl wic to support pppoe clients
Auch für Cisco 2600 Series: Anmerkungen zur Veröffentlichung (32 seiten), Konfiguration (15 seiten), Anwendungshinweis (41 seiten), Datenblatt (6 seiten), Anhang (15 seiten), Installationshandbuch (22 seiten), Übersicht (13 seiten), Schnellstart-Handbuch (2 seiten), Handbuch (5 seiten)

Removing the Power Supply

This section describes how to remove the internal power supply. Although the AC power supply is

shown in the illustrations that follow, the procedure is the same for removing both the AC and DC

power supplies.

Take these steps to remove the power supply:

Step 1

Figure 4

Step 2

Figure 5

Screw

Locate the six-pin connector on the system board near the front of the router, and

disconnect it. (See Figure 4.)

If cable tie-wraps on the harness interfere with removing the connectors, cut the

Note

tie-wraps, being careful not to cut the power supply wires.

Locating the Connectors

Fan

Power connector

Fan connector

Remove the mounting screw that secures the power supply to the chassis. (See Figure 5.)

Set aside this screw for later use.

Removing the Mounting Screw

Installing the Cisco RPS Adapter Plate in Cisco 2600 Series Routers

Removing the Power Supply

AC power supply