Cisco 2800 Series Konfiguration - Seite 7

Blättern Sie online oder laden Sie pdf Konfiguration für Netzwerk-Router Cisco 2800 Series herunter. Cisco 2800 Series 10 Seiten. Cisco ios software configuration
Auch für Cisco 2800 Series: Schnellstart-Handbuch (13 seiten), Datenblatt (8 seiten), Schnellstart-Handbuch (47 seiten), Anwendungshinweis (41 seiten), Schnellstart-Handbuch (45 seiten), Übersicht (27 seiten), Datenblatt (5 seiten), Datenblatt (20 seiten), Konfigurieren von (32 seiten)

Seite drucken

FastEthernet0/1

Select one of the available interfaces for connecting the router to the management network:

Step 8

Enter interface name used to connect to the

management network from the above interface summary: fastethernet0/0

Respond to the following prompts as appropriate for your network:

Step 9

Configuring interface FastEthernet0/0:

Use the 100 Base-TX (RJ-45) connector? [yes]: yes

Operate in full-duplex mode? [no]: no

Configure IP on this interface? [yes]: yes

IP address for this interface: 172.1.2.3

Subnet mask for this interface [255.255.0.0] : 255.255.0.0

Class B network is 172.1.0.0, 16 subnet bits; mask is /16

The configuration is displayed:

The following configuration command script was created:

hostname Router

enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1

enable password xxxxxx

line vty 0 4

password xxxxxx

snmp-server community public

no ip routing

interface FastEthernet0/0

no shutdown

media-type 100BaseX

half-duplex

ip address 172.1.2.3 255.255.0.0

interface FastEthernet0/1

shutdown

no ip address

end

Respond to the following prompts. Select [2] to save the initial configuration:

Step 10

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

Enter your selection [2]: 2

Building configuration...

Use the enabled mode 'configure' command to modify this configuration.

Press RETURN to get started!

The user prompt appears.

Router>

Verify the initial configuration. See the

Step 11

verification procedures.

OL-5788-01

unassigned

unset

"Verifying the Initial Configuration" section on page 9

Power Up and Initial Configuration Procedures for Cisco 2800 Series Routers

Configuring the Router

dow

for